User manual DELONGHI VVX800

[. . . ] If you are right-handed, extract the left wand by pulling out first the back part then the front with an upwards movement (fig. Then position the wand in the housing in line with the other wand (fig. If you are left-handed, perform the above operation with the right wand (fig. To put the wand away after ironing, perform the operation in reverse, inserting first the front part, then the back. [. . . ] - If the thermostat dial is set at a low temperature, turn the steam emission knob towards the minimum. · An open mesh type ironing board is recommended for best results, as this lets the steam through. 11 Topping up the tank with water When the water in the steam generator runs out, the light comes on (fig. 2 minutes) following the same procedure as filling for the first time. This will enable you to continue ironing without interruption. If you top up too late (more than 2 minutes), the system will stop discharging steam. Once the level of water in the tank has been topped up, the appliance will operate as if turned on for the first time. Steam will be ready in 5 minutes and during these 5 minutes you can hear the pump fill 4 or 5 times for about 30 seconds. The steam generator is now stabilised and will operate as normal, filling the water every now and then. When the "no water" light comes on, you should not continue steam ironing with the pump vibrating. Ironing with no water in could irreparably damage your ironing system. fig. 12 Vertical ironing The ironing system can be used for taking creases out and freshening garments on hangers, and curtains. Rotate the wheel forwards (you may wish to use the steam lock) and move the iron up and down the garment. Unless the fabric is cotton or linen we suggest holding the iron a few centimetres away from the material. 5 Ironing system Dry Ironing · Plug the appliance into the mains. · Position the thermostat dial, according to the type of material you are ironing. · When the iron has reached the selected temperature the iron temperature light goes out. When dry ironing do not use the steam wheel. Putting your ironing system away Once you have finished using your ironing system, unplug it and let it cool down. If you put it away immediately after use, be very careful as it will be hot. Ensure that the surface where you are storing it is heat resistant. Safety Warnings · This appliance is designed to iron. Use with extreme care to avoid burns from the steam and avoid any improper use. · When in use, do not touch any of the appliance's hot surfaces. · After unpacking, make sure that the appliance is complete and undamaged. In case of doubt, do not use the appliance and seek the advice of a qualified service professional. [. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. [. . . ]