User manual DELONGHI TRF1 15

[. . . ] Fitting the feet Remove the feet and the wheels from the polystyrene packing. Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. Fit the wheels to the spindles and push firmly until they click into position, then insert the foot in it seat and push it till it hooks into position (see fig. 1). Electrical connection - Before plugging the radiator into the mains, check that your supply voltage is the same as that shown on the rating plate of the radiator. [. . . ] - The heater must be positioned at least 50 cm from furniture or other objects. - If the power cable has been damaged, it must be replaced by the manufacturer or the technical service centre or by a qualified person so as to avoid all risks. - In order to eliminate the radiator's "new" smell, set it to maximum power for at least 8 hours when used for the first time. During this operation, the room in which the radiator is located must be ventilated. - It is perfectly normal for the radiator to make "creacking" sounds when used for the first time. - The radiator must not be located immediately below a fixed socket-outlet. - The body of this radiator is filled with a precise quantity of special TRF1 15 4 oil, so that repairs requiring the opening of the oil body must only be made by the service agent. - Do not use this appliance in rooms having a floor area of less than 4m2 as this can lead to overheating. - If the appliance is scrapped, provisions on the disposal of oil must be respected. - The use of an extension lead is not recommended, as overheating of the extension lead may occur during the operation of the radiator. - As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating your appliance, particularly in the vicinity of young children. The appliance is fitted with a safety device which will switch off it in case of accidental overheating. To reset, contact an authorised service centre. ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. IMPORTANT: Never under any circumstances cover the appliance during operation as this would lead to dangerous overheating. IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. [. . . ] Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. [. . . ]