User manual DELONGHI TRD0715TL

[. . . ] Run the cord away from traffic areas and where it will not be tripped over. To disconnect the heater, switch it OFF, then unplug its cord from the outlet. Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this might cause an electric shock, fire, or damage the heater. Do not place the heater on soft surfaces, like a bed, where openings may be blocked. [. . . ] Keep loose clothing or bedding, furniture and flammable material away from the heater's wall outlet. TURNING ON Insert the plug into an electrical outlet, rotate the thermostat knob (if provided) to maximum and turn the unit on as follows using the power selector: · Turn the power selector to position 1 to select minimum output (the light on the left will come on). Turn the power selector to position 2 to select medium output (the light on the right will come on). Turn the power selector to position 3 to select maximum output (both lights will come on). ADJUSTING THE THERMOSTAT When the room has reached the desired temperature, turn the thermostat knob slowly in a clockwise direction until you get to the setting ­ and not beyond it. The thermostat will then adjust the set temperature automatically and keep it constant. If your unit is a three-output version, in intermediate seasons or on days when temperatures are not particularly cold, select minimum output to optimize savings and consumption. antifreeze function Turn the thermostat dial to the position and the power selector to position 3. The appliance will maintain a minimum room temperature of approximately 42°F (5°C), thus preventing freezing while conserving energy. In models that come with a timer, tabs must be set in the inward position. REMINDER To completely shut the appliance off, turn the power selector to the OFF position and then unplug the appliance from the outlet. TIMER (ON SELECTED MODELS) ABOUT THE TIMER The programmable clock timer allows you to preprogram every 15 minute period of the 24 hour day. CLOCK SETTING The programmable timer, as with all clocks, must be set to the correct time. If for example the time is 1:30pm, rotate the dial clockwise (following the direction of the arrow) until 13:30 is aligned with the triangular pointer. The timer is in effect an electric clock and would only work while it is plugged into a power supply. Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). If you are unable to insert the plug fully into the outlet, try again by turning it the other way. If it would still not go in, it is probably due to an obsolete outlet which should be replaced. Do not tamper with the plug or outlet to defeat the purpose of this safety mechanism. If it is 9:00 pm, turn the numbered timer disk clockwise until the number 21 on the disk coincides with the pointer (2)on the timer. Set the periods of time when you want the appliance to be on by pushing the notches (1) inward, and outward when you want the appliance to be off. When set, the radiator will operate automatically each day during the times programmed (important: the radiator must always be plugged into an outlet). [. . . ] For all accessories, spare parts or replacement parts, please contact our parts division at 1-800865-6330. Residents of Canada: Please contact our toll free hotline at 1-888-335-6644 or log onto our website at www. The above warranty is in lieu of all other express warranties and representations. All implied warranties are limited to the applicable warranty period set forth above. [. . . ]