User manual DELONGHI TRD0715T

[. . . ] Your heater's internal parts may become hot or issue sparks during normal operation. Therefore, you should not use it in areas where gasoline, paint, or flammable liquids are used or stored. Any other use not recommended by the manufacturer might cause fire, electric shock, or personal injury. To prevent overload and blown fuses, be sure that no other appliances are plugged into the same shared outlet, or a separate outlet on the same shared circuit. [. . . ] Check that neither the heater nor the power cable has been damaged in any way during transportation. Make sure that no pieces of polystyrene or other packaging material have been left between heating elements. When switching the heater on for the first time, allow it to run at full power for about two hours to get rid of a possibly unpleasant smell. Make sure that the room where the heater is placed is well ventilated during this first operation. Soft crackling sounds are normal during the heater's first operation. Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. CAUTION Always operate the heater in upright position only (wheels on the bottom, controls on top). WATT ECONOMIZER To conserve energy, use the 1 or 2 position after the unit has reached the desired operating temperature. LOCATION Place heater on the floor beneath the coldest window in the room, or any other location. Do not use this radiator in rooms with a floor area of less than 43 square feet (4 sq. CONNECTION The radiator should be connected to a properly polarized A/C 110/120 V household outlet in perfect working conditions. To change the programming, move the notch back into the initial position and set the new periods of functioning. If you want the appliance to operate without programming, push all the notches to the center. In this case, to shut the appliance off completely, turn the power setting to "0", and unplug the appliance from the outlet. This will avoid continued operation of the timer A safety device The appliance is fitted with a safety device which will switch off it in case of accidental overheating. To reset, disconnect the plug from the power for 30 minutes, remove the cause of overheating then plug the appliance in again. MAINTENANCE AND SERVICE Always unplug the heater from the power outlet and allow the radiator to cool. Wipe radiator with a soft damp cloth; do not use detergents and abrasives. Should the radiator not be in use over a certain length of time, roll the cable around the holder and store it in a dry place. This appliance has been built to last for many years of trouble-free service. In case of malfunction or doubt, do not try to repair the heater by yourself: this might increase the risk of fire and electric shock. We warrant each appliance to be free from defects in material and workmanship. [. . . ] The warranty does not cover defects or damage of the appliance, which result from repairs or alterations to the appliance outside our factory or authorized service centers, nor shall it apply to any appliance, which has been subject to abuse, misuse, negligence or accidents. Also, consequential and incidental damage resulting from the use of this product or arising out of any breach of contract or breach of this warranty are not recoverable under this warranty. Some states do not allow the exclusion or limitation of incidental or consequential damage, so the above limitation may not apply to you. Residents: Please contact our toll free hotline at 1-800-322-3848 or log onto our website at www. [. . . ]