User manual DELONGHI T40 QUICK GUIDE

[. . . ] The use of plastic or non-filter paper bags affects the operation of the appliance and may cause serious damage. 15) Before starting the appliance, ensure that the correct filters are properly in place. 16) Check the filters regularly and, if necessary, clean or replace them. 17) After washing dirty filters, ensure they are completely dry before putting them back in place. [. . . ] 19) Do not wash the appliance with trichloroethylene or other solvents. If the appliance is dropped, left outside, gets wet or is immersed in water, take it to an authorized Technical Service Centre. 22) The power cable of this appliance may not be replaced by the customer. Any time the cable has been damaged, or any time you just wish to replace it, please contact only authorized technical support centres. 23) For all repairs, apply only to the place of purchase or directly to an authorized Technical Service Centre. KEEP THESE INSTRUCTIONS The manufacturer reserves the right to modify the appliance and/or accessories supplied without prior notice. 11 GB 16-04-2004 9:28 Pagina 12 ASSEMBLING THE APPLIANCE Attach the handle (1) by pushing in firmly. 1, A) the through hole and then insert the cord-winding lug and the clamping screw (fig. 2) and screw in. 3 - Attach the desired tool to the end of the vacuum cleaner, pushing it in well. "Explora" brush (some models only) Thanks to the articulated fins, this model is particularly suited to cleaning right up close to furniture and into corners. 1A 1 4 For cleaning wider areas, simply rotate the brush to use the total width (Fig. 5). 2 - Open the front panel of the appliance (7) by pushing the release catch in a downwards direction (fig. Nozzle: for cleaning corners, edges, drawers and all those places which it is difficult for normal fittings to reach. To begin work again, maintain the brush on the ground by pressing with the foot, and pull the sweeper handgrip upwards until the brush joint is released (fig. 13). 13 14 GB 16-04-2004 9:28 Pagina 15 Using the electro-brush (if provided) Some models can mount an electro-brush to clean carpets and rugs. Attach the electro-brush (13) to the suction nozzle (8), pushing it in well. Connect the electro-brush plug to the power take-off on the body of the appliance (fig. When the appliance is turned on, the electro-brush motor starts automatically. The appliance can now be used for cleaning all types of textile surface. Replacing the paper bag Push the release catch on the front panel in a downwards direction (6) and open the panel. To remove the bag, take hold of the cardboard collar, tilt it slightly and pull it out from the guides (fig. To insert the new bag, slide the cardboard collar into the special guides, and push in firmly. To close the panel again, slot the teeth into the special holes. 15 14 Motor filter maintenance The motor filter must always be kept clean to ensure the absolute cleanliness of the air expelled by the appliance, and to give maximum suction and optimum motor cooling. Open the front panel (5), and remove the motor filter positioned above the paper bag. To maintain efficiency, just wash it occasionally in water and normal detergent. . WARNING: do not use the electro-brush on rug fringes as these could become entangled in the rolle CLEANING AND MAINTENANCE Always unplug the appliance before carrying out any maintenance or cleaning work. Insufficient suction The full bag indicator (4) on the front panel becomes red when the dustbag needs replacing or if the air flow is obstructed. [. . . ] In the second case, check the suction nozzle (8) and remove the obstruction that caused the light to come on. 15 GB 16-04-2004 9:28 Pagina 16 Replacing the microfilter Open the filter holder grid (fig. 16), at the rear of the appliance, remove the microfilter, replace it with a new one and close. The microfilter should be changed often (after every 2-3 dust bag replacements) to prevent the circulation of bacteria in the room. Storing the appliance Wind the cord around the special winding lugs on the appliance (fig. The appliance may be hung on a wall by fixing a screw and dowel to the wall and attaching the unit by way of the hole at the back of the handle (A), or it may be placed in a vertical position and leant against the wall. A 16 If your appliance is fitted with an active carbon filter, this should also be changed after every 2-3 dust bag replacements or when it has become stiff, to ensure effective filtration of unpleasant odours. 17 ELECTRICAL CONNECTION (UK ONLY) A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. [. . . ]