User manual DELONGHI SFA 2042

[. . . ] INSTRUCTIONS ELECTRIC STOVE Proudly distributed by De'Longhi New Zealand Limited 25 Carbine Road Mt Wellington Auckland, New Zealand PO Box 58-056 Greenmount Manukau 2141 Auckland, New Zealand Customer Service Ph: 0508 200 300 Fax: 0508 200 301 e-mail:delonghi@delonghi. co. nz Australia Po Box 4156 MILPERRA BC NSW 1891 Customer Service Ph: 1800 126659 Fax: 1800 706932 e-mail: delonghi@delonghi. com. au Description of appliance Q M O I H N L P A B F G E D DESCRIPTION OF APPLIANCE A) Fire effect shield B) Door C) Function slider D) Hot air output grille E) Thermostat dial F) Coal/pebbles/logs support shelf G) Flame effect dimmer H) Decorative flue I) Wall flange marked "wall" L) Stove flange marked "stove" M) Wall screw N) Stove screw O) Drilling template P) Hole cover Q) Fixing plug C 2 Thank you for choosing this De'Longhi heater. To get the very best out of your new heater it is advisable to read these instructions before using it. This will ensure that you gain optimum results and use the appliance safely. [. . . ] This temperature will be regulated automatically and kept constant by the thermostat. 3 Automatic Safety Cut Out This heater is fitted with an automatic cut out device to prevent any damage due to overheating. To reset the stove, disconnect the plug from the power socket for a few minutes, remove the cause of obstruction and allow a suitable cooling period before plugging it in again. Flame effect dimmer The appliance has a fire effect intensity regulator enabling the flame light to be increased or reduced. 2 Noise As with all fan driven appliances the stove will make some noise due to the movements of air occurring, this is perfectly normal. Installing the flue If you want to install the flue, proceed as follows: remove the hole cover by pressing on one side only (fig. fit the stove flange (L) in the hole and screw on with the stove screw supplied (fig. move the stove near the wall and place the drilling templa te between the pipe and the wall to establish the correct position for the hole in the wall. fix the drilling template with adhesive tape or a suitable alternative (fig. fix the wall flange (I) to the wall with the wall screw and fixing plug supplied. Maintenance Before any maintenance/cleaning is undertaken always disconnect the stove from the power supply and allow to cool down. Replacing light bulbs Tools required: correct screwdriver (not included in the box). Remove the coal, pebbles, or logs from the internal support shelf, then remove the support by removing the screw provided as shown in fig. The light bulbs must be replaced only with 40W 220-240V screw type E27. Please note that replacement bulbs are not covered by the guarantee of the product. 4 Fig. Service and Customer Care If the cord is damaged it must, for safety reasons, be repaired by De'Longhi or an authori sed De'Longhi repairer. Please refer to the enclosed guarantee leaflet for service and assistance details. SAFETY WARNINGS · Do not use the stove in a bathroom or in the vicinity of bathtubs, washbasins, showers or swimming pools. [. . . ] Children should be supervised to ensure that they do not play with the appliance · The front face of the heater must be positioned at least 50 cm from furniture, walls, curtains, or other objects. WARNING: In order to avoid overheating, never under any circumstances cover the appliances during operation, as this would lead to dangerous overheating. 5 PROBLEM SOLVING No power to the fire Check the wall socket, plug and fuse No Illumination/ flame effect Check that fire is switched on. Check that the bulbs are working. Heater cuts out/ poor or no flame effect Check that airflow around the stove is not obstructed or the product is covered in any way. 6 5713110041/01. 08 [. . . ]