User manual DELONGHI SCF 2000

[. . . ] When the appliance is to be discarded, after unplugging from the mains, the lead should be cut to make the appliance unusable. Never use accessories or devices other than those provided by the manufacturer. For all technical operations, including replacement of the power cable, contact authorised service centres only to avoid all risk 11. Never direct jets of water directly at the appliance. [. . . ] · Fix the brackets "D" in the drilled holes, using the screws and anchors provided. · Hang the towel warmer on the two brackets previously mounted on the wall, check that the appliance is perpendicular to the floor and if necessary adjust by regulating the brackets "D" as shown in figure 5. Mark the positions of the remaining fixing points on the wall ("B" only for the single version SCF1000, "B" and "C" for the double version SCF2000); · Remove the towel warmer, drill the remaining holes in the wall and insert the anchors. · Re-hang the towel warmer on the brackets and fix with the screws supplied, then fit the covers provided (fig. 2); The appliance must not be installed immediately under a fixed socket and must be positioned in such a way that the plug is accessible. DESCRIPTION A. Fixing points (SCF1000/SCF2000) Fixing points (SCF1000/SCF2000) Fixing points (SCF2000) Bracket "ON" indicator light "Timer on" indicator light Programme "P " (heated rail) Programme "P (convection heater) "MAN" button "Clock set" button (setting time) Thermostat knob 12 DESCRIPTION OF DISPLAY Functioning in Timer mode Functioning in Manual mode AUTO MAN No. of automatic programme ON OFF "Convection heater" symbol ON time setting OFF time setting "Heated rail" symbol OPERATION AND USE 1. Setting the clock When connecting to the mains for the first time or each time the mains supply comes back on, "00:00" flashes on the display. You can now set the clock by pressing the "Clock Set" button and proceeding as follows: · single pressure of the "Clock Set" button · first 20 seconds of continuous pressure · continuous pressure after 20 seconds the clock goes forward one minute; the clock goes forward slowly; the clock goes forward fast. While the time is being set, the display flashes. Once setting has been completed, the flashing continues for several seconds, then indicates the exact time steadily. To set the clock again, just hold the "Clock Set" button down for several seconds until the time display starts to flash The time can now be set following the instructions described above. Functioning in manual mode When connecting to the mains for the first time or each time the mains supply comes back on, the appliance is in manual mode ("MAN" displayed at the top right). Pressing the "MAN" button once turns the towel warmer on (" " appears on the right of the display and the "ON" light comes on). Pressing the I "MAN" button again deactivates the heated rail and turns power to the convection heater on (" " appears on the right of the display and the "ON" light is on). Pressing the I "MAN" button again turns power to both the heated rail and convection heater on (" " and " " appear on the right of the display and the "ON" light is on). Further pressing of the I "MAN" button returns the appliance to the original state (appliance off and "0" on the display). 13 Heated rail on Appliance off Convection heater and heated rail on Convection heater on Adjusting the thermostat Start with the thermostat knob in the Max position. When the room has reached the required temperature, turn the thermostat slowly until the convection heater goes off and no further. The thermostat will automatically regulate the temperature set and keep it constant. [. . . ] Notes: If no OFF time is set, the system automatically takes "00:00"; If no ON time is set ("--:--" is displayed), the system automatically skips setting of the OFF time and the programme can be considered "not active". After programming, if at least one automatic programme is active, "AUTO" and the "timer on" LED light come on. The symbols of the programmed elements appear on the right (heated rail only, convection heater only or both). [. . . ]