User manual DELONGHI PRIMA DONNA CLASSICO

[. . . ] The pebbles/coal are found within the packaging down the sides of the stove, so ensure that the accessories are removed before discarding any packaging. FITTING THE LEGS Remove the legs from the polystyrene packaging. Lay the stove on its back on a rug or soft surface in order to prevent damaging the paint finish. Screw the three legs firmly into the three holes in the base of the stove and place it in an upright position. POSITIONING OF THE STOVE Your stove is designed for use throughout your living area, such as against a wall, in a corner or within a fireplace to add instant warmth and ambience. [. . . ] De'Longhi Customer Services: 0845 6006845 OPERATING THE STOVE The stove is controlled by a row of 3 switches located above the stove's front right leg. Turning on the Light Pattern and Flame Effect The light pattern can operate with or independently from the heat. The nearest switch to the front of the stove turns the light pattern on and off. Pressing this switch down, turns the light pattern on with no heat, so that you may enjoy the flame effect all year round. Heat Levels For minimum heat, press the switch marked with one bar (1kW). For maximum heat, press both the switch marked with one bar and the switch marked with two bars (2kW). Automatic Safety Cut Out This heater is fitted with an automatic cut out to prevent any damage due to overheating. To reset the stove, disconnect the plug from the power socket for a few minutes, remove the cause of obstruction and allow a suitable cooling period before plugging it in again. Noise As with all fan driven appliances the stove will make some noise due to the movements of air occurring, this is perfectly normal. MAINTENANCE Before any maintenance/cleaning is undertaken always disconnect the stove from the power supply. Replacing light bulbs The Prima Donna comes fitted with two 60W daylight (craftlight) bayonet cap bulbs. The Prima Donna Classico comes fitted with two 40W red bayonet cap bulbs. To change the bulbs you will need to remove the silver front panel, but first, allow a suitable time for the bulbs to cool. 3 The bulbs can easily be changed as follows: 1. Carefully pull the top of the panel towards you, away from the magnets 3. Replace the panel by relocating and sliding the pegs back into their holes and pushing the top of the panel to reconnect with the magnets. Please note that replacement bulbs are not covered by the guarantee of the product. Do not use metal polish or harsh scouring agents. WARNINGS · Do not use the stove in a bathroom or in the vicinity of bathtubs, washbasins, showers or swimming pools. · Never install the stove directly underneath a fixed mains socket. · If the supply cord is damaged, it must be replace by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. · The use of an extension lead is not recommended, as overheating of the extension lead may occur during the operation of appliance. · In order to avoid any danger caused by accidental resetting of the safety system, this appliance must not be powered through an external timer. [. . . ] If the plug is a moulded-on type, the fuse cover must be refitted when changing the fuse using a 13amp Astra approved fuse to BS1362. In the event of losing the fuse cover, the plug must not be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that marked on the base of the plug. WARNING - THIS APPLIANCE MUST BE EARTHED IMPORTANT The wires in the mains lead are coloured in accordance with the following code: E L N Green and yellow: Earth Blue: Neutral Brown: Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol or coloured green or green and yellow. [. . . ]