User manual DELONGHI PENTAVAP EL. W F

[. . . ] Delivery lever Delivery tube connection Motor unit Water or water + shampoo selector knob connection Water or water + shampoo selector knob External tank Clips Liquid level indicators Liquid collection drum Handgrip Manual suction power regulator Motor unit handle Electronic suction power regulator (electronic version only) Delivery tube connection Motor housing Delivery tube Hose coupling Vacuum on light Vacuum button "Cleaning off" button Cold water cleaning button Hot water cleaning button Steam cleaning button "Cleaning on" light Tools 25. Hard floor attachment Important information for correct disposal of the product in accordance with EC Directive 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. [. . . ] Connect the delivery tube to the drum, pushing it in until the release/lock button clicks. Connect the extension tubes (26) to the handgrip (10) then fit the tool most suitable for the cleaning to be performed to the other end. Perfect for hard-to-reach corners, such as between radiators, car interiors, etc. I) Multipurpose nozzle (31) Use to clean sofas, upholstery, car interiors, curtains, etc. Brush tool (32) Use to remove dust from upholstery, furniture, books, curtains, picture frames and clothes (fig. WET VACUUMING This function of the PENTAVAP enables the appliance to be used to tackle those minor household emergencies requiring liquids to be collected, such as blocked sinks or drains, small floods (washing machine, dishwasher, cellars etc. ), without immersing the appliance in the water. Set the appliance up as described in point 1 (dry vacuum function). Crevice tool (32) Use to vacuum up liquids from hard-to-reach points and blocked sinks. Small triangular nozzle (40) Use the small triangular nozzle to wash and wet vacuum upholstery, sofas, furniture and hanging fabrics. Connect the delivery tube to the hose handgrip and push as far as it will go until the release/lock button clicks (fig. Large triangular nozzle (47) Useful for picking up liquids from floors, carpets and rugs. When using on hard floors, fit the hardfloor attachment (48). WET VACUUMING TOOLS In the event of difficulty, first empty the diffuser cone. EXTRACTION CLEANING The appliance uses cold water to protect floors and fabrics while cleaning, hot water to remove tougher dirt and steam for perfect hygiene on all types of surface. IMPORTANT: make sure the fabrics and surfaces to be cleaned are suitable for and resistant to extraction cleaning. If in doubt, try on a corner of the rug or surface to be cleaned and wait until completely dry to verify the result. NB: if the fabric surface being cleaned has been previously washed using shampoo other than the type supplied, this may cause excessive foam to form inside the drum. If foam leaks from the head, switch the appliance off immediately and empty the drum. Set the appliance up as described in point 1 (dry vacuum function). Plug the appliance into the mains socket and turn on using the vacuum button (fig. IMPORTANT: the appliance can hold around 8 litres of water in the liquid collection drum. Over this level, a special device stops suction and the motor increases speed. If this occurs, you should turn off the motor, unplug the appliance and empty the liquid collection drum. TURNING ON To empty the drum, the following must be removed in sequence (fig. N): - water or water + shampoo selector (5); - delivery tube (16); - hose coupling (17); - external tank (6); - motor unit of the appliance (3). This provides a combined steam + brush action for more thorough cleaning (fig. [. . . ] Plug the appliance into the mains socket and press the vacuum (19) and cold water (21) buttons. Use the same technique as for cleaning (see sec- RINSING NB: do not press the extraction cleaning buttons if there is no detergent solution or water in the tanks, or when the appliance is being used as a dry or wet vacuum cleaner. In the event of incorrect use of the pump (function activated and no detergent solution available for more than 15 minutes), a safety device stops pump operation to prevent damage. If this occurs, wait around 30 minutes before starting the appliance again. extracting (fig. [. . . ]