User manual DELONGHI PACT 130ARC

[. . . ] De'Longhi S. p. A. Via Seitz, 47 31100 TREVISO Italy www. delonghi. com 5751020100/07. 07 T130ARC AIR CONDITIONER CLIMATISATEUR CLIMATIZADOR CONDIZIONATORE GB IMPORTANT SAFEGUARDS · Use this appliance only as described in this instruction manual. As with all electrical equipment, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating and installing this appliance. · This appliance is designed to air condition and heat the home and must not be used for other purposes. · It is dangerous to modify or alter the characteristics of the appliance in any way. [. . . ] NB: In order for the continuous drain function to operate correctly, make sure the accessory is fully connected to the coupling. To release, press the coupling flange. 8 15 16 1 2 AIR PURIFYING/FAN MODE (FIG. 17) When using the appliance in this mode, the air exhaust hose does not need to be attached. To set this mode correctly: · Press the MODE button a number of times until the fan symbol appears (5). · Select the required fan speed by pressing the FAN button. Three speeds are available: High speed: for maximum fan power Medium speed: reduces noise levels but still maintains a good level of comfort Low speed: for silent operation In this mode, AUTO speed cannot be selected. 17 HEATING MODE (FIG. 18) To set this function correctly: · Press the MODE button a number of times until the heating symbol (6) appears. · Select the required temperature by pressing the + or - button until the corresponding value is displayed. · In heating mode, the fan speed is selected automatically by the appliance. Water is removed from the air and collected in the tank at the back of the air conditioner. When the tank is full, the appliance shuts down and (full tank) appears on the display. The continuous drain hose accessory enables the condensate produced to be eliminated without requiring the tank to be emptied periodically. To use the continuous drain function, fit the hose with the rapid coupling as shown in fig. N. B. :-When operating in very cold rooms, the appliance defrosts automatically, momentarily interrupting normal operation. During this operation, it is normal for the noise made by the appliance to change. - In this mode, the fan may operate for short periods, even though the set temperature has already been reached. 18 SMART MODE (FIG. 19) In this mode, the appliance automatically sets the operating mode (air conditioning, fan, heating), the most suitable temperature for optimum well-being and the fan speed. To set this mode: · Press the MODE button a number of times until the SMART symbol appears. 19 SWING BUTTON (15) Moves the grille flaps to distribute the cool air uniformly in the room. Hold the button down to run rapidly through first the minutes, then the tens of minutes and then the hours. · Once the correct time has been reached, press the SET button to confirm. If you need to change the time later, press the SET button, then set as described above. To cancel the settings programmed on the remote control and restore the original settings, press the RESET button lightly with the point of a pencil or pen. USING THE REMOTE CONTROL UNIT The ON/Stand-by, MODE, FAN + and - buttons correspond to the equivalent buttons on the control panel. MODE BUTTON: Selects modes: AIR CONDITIONING, DEHUMIDIFYING, AIR PURIFYING, FAN, HEATING, SMART. [. . . ] · make sure the air conditioner is standing on a level surface. if necessary, place the castor locks under the front wheels. 28 close doors and windows 29 close curtains 30 AIR PURIFYING FILTERS The T130ARC model is fitted with a dust filter which retains impurities in the air drawn in from the room and a 3M® electrostatic filter (fig. 31) do not cover the appliance SILVER ION FILTER The silver ion filter not just retains dust particles, but also has an efficient antibacterial action. It also greatly reduces concentrations of irritants such as pollen and spores. [. . . ]