User manual DELONGHI PACT 110A

[. . . ] IMPORTANT SAFEGUARDS GB · Use this appliance only as described in this instruction manual. As with all electrical equipment, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating and installing this appliance. · This appliance is designed for home air conditioning and must not be used for other purposes · It is dangerous to modify or alter the characteristics of the appliance in any way. · The appliance must be installed in conformity with national legislation regulating electrical equipment and installations. [. . . ] When turned on for the first time, the appliance will be in "air conditioning" mode. Subsequently it will be in the same mode as when turned off. Never turn the air conditioner off by unplugging from the mains. Always press the button, then wait for a few minutes before unplugging. This allows the appliance to perform a cycle of checks to verify operation. 25 13 AIR CONDITIONING MODE (FIG. 13) Ideal for hot muggy weather when you need to cool and dehumidify the room. To set this mode correctly: · Press the MODE button a number of times until the air-conditioning symbol appears. · Select the target temperature by pressing the + or - button until the corresponding value is displayed. Four speeds are available: High speed: to achieve the target temperature as rapidly as possible Medium speed: reduces noise levels but still maintains a good level of comfort Low speed: for silent operation AUTOFAN: the appliance automatically selects the most suitable fan speed in relation to the temperature set on the digital display. The most suitable temperature for the room during the summer varies from 24 to 27°C. You are recommended, however, not to set a temperature much below the outdoor temperature. 14) Ideal to reduce room humidity (spring and autumn, damp rooms, rainy periods, etc). The remote control must be no more than 7 metres away from the appliance (without obstacles between the remote control and the receiver). Do not drop it or expose it to direct sunlight or sources of heat. MAX. 7 metres 28 INSERTING OR REPLACING THE BATTERIES · Remove the cover on the rear of the remote control (fig. 19); · Insert two R03 "AAA" 1. 5V batteries in the correct position (see instructions inside the battery compartment); · Replace the cover. 19 If the remote control unit is replaced or disposed of, the batteries must be removed and discarded in accordance with current legislation as they are harmful to the environment. SETTING THE TIME After having inserted the batteries, the clock on the display flashes until the time is set. Proceed as follows: · Press the + or - button until the correct time is reached. Hold the button down to run rapidly through first the minutes, then the tens of minutes and then the hours. · Once the correct time has been reached, press the SET button to confirm. If you need to change the time later, press the SET button, then set as described above. To cancel the settings programmed on the remote control and restore the original settings, press the RESET button lightly with the point of a pencil or pen. USING THE REMOTE CONTROL UNIT The ON/Standby, MODE, FAN + and - buttons correspond to the equivalent buttons on the control panel. MODE BUTTON: Select modes: AIR CONDITIONING, DEHUMIDIFYING, AIR PURIFYING, FAN, SMART FAN BUTTON: selects fan speed (High, Medium, Low, Auto) + and - BUTTON: increase and decrease To use these buttons see the section "Operating from the control panel". The following section describes the additional functions corresponding to the controls on the bottom part of the remote control. 20 BOOST FUNCTION (FIG. [. . . ] NB: in dehumidifying mode, it is normal for this message to appear. LOW TEMPERATURE (frost prevention) FULL TANK If this is displayed, contact your local authorised service centre. If this is displayed, contact your local authorised service centre. PROBE FAILURE (sensor damaged) FAILURE 1 (pump failure) 31 TIPS FOR CORRECT USE To get the best from your air conditioner, follow these recommendations: · close the windows and doors in the room to be air conditioned (fig. When installing the air conditioner semi-permanently, you should leave a door slightly open (as little as 1 cm) to guarantee correct ventilation. · Protect the room from direct exposure to the sun by partially closing curtains and/or blinds to make the appliance much more economical to run (fig. 30); · never rest objects of any kind on the air conditioner; · do not obstruct the air intake and outlet (fig. [. . . ]