User manual DELONGHI PAC CT110

[. . . ] Important safeguards · Use this appliance only as described in this instruction manual. As with any electrical appliance, the instructions aim to cover as many situations as possible. Caution and common sense should be used when operating and installing this air conditioner. · This appliance has been manufactured to cool and dehumidify domestic environments and must not be used for other purposes. [. . . ] If the + (E) or - (F) buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24 hours. Press the timer button again within a few seconds to confirm the setting. If the setting is not confirmed within a few seconds, the display resets to Stand-by. With the timer activated, the countdown before the programmed start up time is displayed and the light (H) flashes. To cancel the timer programming, press the timer button (D) again. How to program delayed shutdown · Delayed shutdown can be programmed in any operating mode (air conditioning/dehumidifying/fan). The last timer setting or the preset value 6. 0 flashes on the display. · Use the + (E) or - (F) button to set the number of hours delay before the appliance goes off. If the + (E) or - (F) buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24 hours. Press the timer button again within a few seconds to confirm the setting. At the set time, the air conditioner shuts down and remains in stand-by. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 10 Using the remote control TURNING THE APPLIANCE ON Plug into the outlet. Press the ON/STAND-BY button (17) (when turned on, the air conditioner starts operating in the same mode as when it was turned off). Press the MODE button (18) to select the required mode: AIR CONDITIONING ( ) DEHUMIDIFYING ( ) FAN ONLY ( ) An arrow on the display indicates the selected mode. GB AIR CONDITIONING MODE ( ) Ideal for hot humid weather when you need to cool and dehumidify the room. In air conditioning mode, use the buttons to select the desired temperature. To change the fan speed, use the fan button (16) on the remote control, choosing from the available speeds: the appliance automatically selects the most suitable fan speed in relation to the temperature set on the digital display and current room temperature. the air conditioner operates at maximum to reach the required temperature as rapidly as possible. Two arrows on the display indicate respectively air-conditioning and the fan speed. The most suitable temperature for the room during the summer varies from 24 to 27°C. You are recommended, however, not to set a temperature much below the outdoor temperature. DEHUMIDIFYING MODE ( ) Ideal to reduce room humidity (spring and autumn, damp rooms, rainy periods, etc). Two arrows on the remote control display indicate and respectively. FAN MODE ONLY ( ) In fan mode, fan speed can be set by pressing the fan button (16). In this mode, the auto speed cannot be selected. SETTING THE TIMER The timer can be used to delay appliance start up or shutdown. [. . . ] absorbed power during air conditioning Refrigerant Cooling capacity see rating label " " " Transport, filling, cleaning, recovery and disposal of refrigerant should be performed by a technical service centre appointed by the manufacturer only. The appliance should be disposed of by a specialist centre appointed by the manufacturer only. LIMIT CONDITIONS Room temperature for air conditioning 64 ÷ 95°F (18° ÷ 35°C) NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. (After the unit has been on its side, oil needs to return to the compressor to ensure proper function. [. . . ]