User manual DELONGHI PAC C100

[. . . ] Important safeguards · Use this appliance only as described in this instruction manual. As with any electrical appliance, the instructions aim to cover as many situations as possible. Caution and common sense should be used when operating and installing this air conditioner. · This appliance has been manufactured to cool and dehumidify domestic environments and must not be used for other purposes. [. . . ] With the timer activated, the countdown before the programmed start up time is displayed and the light (H) flashes. How to program delayed shutdown · Delayed shutdown can be programmed in any operating mode (air conditioning/dehumidifying/fan). The last timer setting or the preset value 6. 0 flashes on the display. · Use the + (E) or - (F) button to set the number of hours delay before the appliance goes off. · This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. TURNING THE APPLIANCE ON Plug into the outlet. Press the ON/STAND-BY button (17) (when turned on, the air conditioner starts operating in the same mode as when it was turned off). Press the MODE button (18) to select the required mode: AIR CONDITIONING (COOL) DEHUMIDIFYING (DRY) FAN ONLY (FAN) An arrow on the display indicates the selected mode. AIR CONDITIONING MODE (COOL) Ideal for hot humid weather when you need to cool and dehumidify the room. In air conditioning mode, use the buttons to select the desired temperature. To change the fan speed, use the fan button "FAN" (16) on the remote control, choosing from the available speeds: AUTO: the appliance automatically selects the most suitable fan speed in relation to the temperature set on the digital display and current room temperature. HIGH: the air conditioner operates at maximum to reach the required temperature as rapidly as possible. MED: reduces noise levels while maintaining a comfortable temperature. Two arrows on the display indicate respectively air-conditioning "COOL" and the fan speed. The most suitable temperature for the room during the summer varies from 24 to 27°C. You are recommended, however, not to set a temperature much below the outdoor temperature. 12 Setting the timer DEHUMIDIFYING MODE (DRY) Ideal to reduce room humidity (spring and autumn, damp rooms, rainy periods, etc). Two arrows on the remote control display indicate "DRY" and "AUTO" respectively. GB FAN MODE ONLY (FAN) In fan mode, fan speed can be set by pressing the fan button "FAN" (16). In this mode, the AUTO speed cannot be selected. SETTING THE TIMER The timer can be used to delay appliance start up or shutdown. This avoids wasting electricity by not operating the appliance when it is not needed. [. . . ] Without allowing the unit this time (6-24 hours) the unit may function for only a short time, and then the compressor will break down from lack of oil. ELECTRICAL CONNECTION This appliance is equipped with a 3 prong grounded plug. The plug must be connected into an outlet that is properly installed and grounded in the accordance with all local codes and ordinances. If it will not fit the outlet, have a proper outlet installed by a qualified electrician or relocate the unit to a proper outlet. If the household electrical supply does not meet the above specifications, or if you are not sure your home has an effective electrical ground, have a qualified electrician or your local electrical utility company check it and correct any problems. SAFETY PLUG The appliance is fitted with a safety plug to protect the power cable. [. . . ]