User manual DELONGHI PAC 46

[. . . ] · The appliance should not be installed where the atmosphere may contain combustible gases, oil or sulphur, or near heat sources. · Remember to perform the descaling procedure at the end of each season (see page 25). In areas where the water is particularly hard (rich in minerals), the use of a commercial anti-lime product added to the water is recommended. If this is not possible secure the unit at an angle, do not lie horizontally. · Before transporting the unit drain the condensation collecting-tray and tank. [. . . ] This can be drained by removing the bung from the drain hose 10 and draining into a suitable receptacle. IMPORTANT: if the room temperature is 32°C or over the airconditioner must be operated with with water in the tank. 20 GB-5751010700 15-01-2004 16:33 Pagina 21 Setting the timer ELECTRICAL CONNECTION Before plugging in check that: · the mains supply corresponds to the power supply shown on the rating plate; · the socket and the mains lead correspond to the power requirements of the appliance; · the socket is suited to the plug, otherwise have the socket replaced; · the socket is properly grounded. The manufactures cannot be held responsible for any damages due to failure in following normal safety procedures. Replacement of the power cable must be carried out by qualified personnel. PROGRAMMED MODE 1) Set the operating times by pushing out the notches on the dial corresponding to the period required (each notch represents 15 mins. ) 2) Press the TIMER key 13 , the signal light 15 will come ON. 3) Make sure that the timer indicates the correct time (see instructions on setting). operating time Funzionamento 21 20 19 SETTING THE TIMER (if supplied) The programmer/timer 14 , like all clocks, must be set to the exact time. (16. 00), turn the dial in a clockwise direction (following the direction of the arrow) until the number 16 is lined up with the triangular pointer (the arrows indicates 4:00 P. M. approximately ). 4) Select the desired function as shown in the chart overleaf. N. B. : To override the programmed operating times, simply press the ON/OFF key 13 (the timer signal lamp ON will go out) 21 20 19 pointer N. B. : Never turn the dial in an anti-clockwise direction! The timer is in effect, an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the programmer stops (the clock is then "slow") and must be re-set. 21 ITALIANO ITALIANO ITALIANO ITALIANO ITALIANO ITALIANO ITALIANO ENGLISH ITALIANO 16 16 GB-5751010700 15-01-2004 16:33 Pagina 22 Turning on and Selecting functions AIR CONDITIONING FUNCTIONS To turn the unit on in air conditioning mode, proceed as follows: 1. Press the button 12 (the signal light "I" 11 will come on). Delay on Start Up 1. A special safety device will delay the start of air conditionig by approximately 3 to 5 minutes when switching between functions or on initial start up. You may also experience a slight delay between changing from one function to another. 2. Rotate the function selector 16 dial anticlockwise: · Place the large star symbol in line with the reference mark to operate the unit in air conditioning mode at maximum fan speed. · Place the small star symbol in line with the reference mark to operate the unit in air conditioning mode at minimum fan speed. Now set the required temperature by rotating the room thermostat dial 17 . VENTILATION/FILTRATION Rotate the function selector 16 clockwise. · Press the button 12 (the signal light "I" 11 will come on). · Place the large symbol in line with the reference mark to operate the unit at maximum fan speed. · Place the small symbol in line with the reference mark to operate the unit at minimum fan speed. Note The temperature is not expressed in degrees. We recommend that you turn the thermostat dial to the maximum position. When the desired room temperature has been reached, slowly turn the thermostat 17 in a clockwise direction until it arrives at the position where a click can be heard. The temperature selected in this way will automatically be regulated and maintained, and save energy. When regulating the thermostat, the air conditioning function is temporarily interrupted and the unit continues to operate in fan only mode. In this way, the appliance keeps the air temperature within the room even. TURN THE APPLIANCE OFF TO TURN THE UNIT OFF COMPLETELY, PRESS THE BUTTON 12 (THE SIGNAL LIGHT 11 WILL TURN OFF). 22 GB-5751010700 15-01-2004 16:33 Pagina 23 Recommendations RECOMMENDATIONS Follow these recommendations to achieve maximum efficiency from your air conditioning unit: · Close the doors and windows in the room where the unit is functioning. [. . . ] If it does not fit your socket, the plug should be cut off from the mains lead, and on appropriate plug fitted, as below. warning: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a mouldedon type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. [. . . ]