User manual DELONGHI PAC 166

[. . . ] Avoid using Pinguino in oily or sulphurous atmospheres or near sources of heat. Before moving the air conditioner, empty water from condensation tray (see drainage instructions on page 15). To disconnect, turn control to "OFF", then unplug from wall socket. Important: if an extension is required, use heavy duty cable only (minimum 14 gauge - SAVE THESE INSTRUCTIONS 4 GB-5751012600 16-02-2004 15:55 Pagina 5 ing the summer, optimum comfort is achieved with a temperature of between 75-80°F (2427°C) and about 50% relative humidity. [. . . ] We do not advise selection of temperatures much lower than those outside. Select fan speed by pressing the "FAN" button (Q) until the fan speed indicator appears: MAX (P): if you want the maximum power of the air-conditioner to reach the desired temperature as quickly as possible. MIN (O): if you want to reduce the level of noise and still maintain a good level of comfort. SILENT (N):when minimum noise is required, AUTO (M):if you prefer the appliance to select the fan speed for the temperature selected on the display panel. 77 DEHUMIDIFYING FUNCTION This function is ideal for reducing humidity in the atmosphere while avoiding increases or decreases in temperature (in between seasons, damp places, wet spells of weather). When you select the dehumidifying function, the letters " " will appear on the display. When the tank is full, the appliance will stop working and the display will show the letters " " (Full Tank); the tank must then be emptied. remove the air exhaust hose (14). In the air-conditioning function, the unit employs an exclusive condensation recycling system to dispose of excess moisture. When the humidity is particularly high, an excess of condensation may built up in the TANK 9 . When this happens, the display will show the letters " " (Full Tank); indicating that the TANK should be emptied. Whenever conditions of high humidity make the problem recurrent, you may discharge the excess water directly into a drain, using the rubber tube supplied. The tube should be inserted into the hole provided, after having removed the rubber stopper. Make sure the TANK is put back correctly otherwise the display will continue to show the letters " " 11 ENGLISH Operation GB-5751012600 16-02-2004 15:55 Pagina 12 Operation Once the dehumidifying function has been selected, the fan speed cannot be changed. "Silent" speed VENTILATION Adjust the fan speed by pressing the "FAN" (Q) button, as illustrated in the air conditioning function. Bear in mind that the higher the speed, the greater the volume of air filtered; by selecting the "Silent" speed, less air is filtered, but the noise level is low. "Min" speed "Max" speed PROGRAMMING THE TIMER The timer programs the appliance to switch on and switch off. The timer is set using the buttons + (F) or ­ (G); these increase and decrease by one hour at a time, but if pressed for more than 2 seconds will automatically change the time more quickly, up to a maximum of 24 hours. How to set the delayed start function · Connect the appliance to the mains supply and press ON/OFF button: next, select the required operating mode (temperature, fan speed etc. ) · Press the ON/OFF button again: the appliance will go into stand-by mode. · Press the timer button (I): on the display the two central segments will start to flash. · Set the number of hours after which the appliance should switch on, by pressing the + or ­ buttons. The indicator (L) on the display will continue to flash until the appliance starts operating. [. . . ] Residents of Canada: Please contact our toll free hotline at 1-888-335-6644 or log onto our website at www. delonghi. com. Residents of Mexico: Please refer to the Limited Warranty statement for Mexico. Please refer to the back page of the manual for De'Longhi addresses. The above warranty is in lieu of all other express warranties and representations. [. . . ]