User manual DELONGHI PAC 160

[. . . ] Avoid using Pinguino in oily or sulphurous atmospheres or near sources of heat. Before moving the air conditioner, empty water from condensation tray (see drainage instructions on page 15). To disconnect, turn control to "OFF", then unplug from wall socket. [. . . ] The manufactures cannot be held responsible for any damages due to failure in following normal safety procedures. Replacement of the power cable must be carried out by qualified personnel. 10 pac160 GB 25-01-2003 10:19 Pagina 11 SWITCHING THE APPLIANCE ON Connect the appliance to the mains supply. On the display two lines will appear indicating Stand-by mode Press the ON/OFF button (A) and then the MODE button until the relevant function indicator appears viz. : Indicator C Indicator D Indicator E : air-conditioning : dehumidifying : ventilation AIR-CONDITIONING FUNCTION This function is ideal in hot, humid weather conditions when the atmosphere requires to be cooled and dehumidified. To ensure proper function of the appliance, after selecting the airconditioning function, press buttons + (F) or ­ (G) until the desired temperature appears on the display. The temperatures most suited to the atmosphere in summer vary between (24-27°C) 75°-80°F. We do not advise selection of temperatures much lower than those outside. Select fan speed by pressing the "FAN" button (Q) until the fan speed indicator appears: MAX (P): if you want the maximum power of the air-conditioner to reach the desired temperature as quickly as possible. MIN (O): if you want to reduce the level of noise and still maintain a good level of comfort. SILENT (N):when minimum noise is required, AUTO (M):if you prefer the appliance to select the fan speed for the temperature selected on the display panel. 77 DEHUMIDIFYING FUNCTION This function is ideal for reducing humidity in the atmosphere while avoiding increases or decreases in temperature (in between seasons, damp places, wet spells of weather). When you select the dehumidifying function, the letters " " will appear on the display. When the tank is full, the appliance will stop working and the display will show the letters " " (Full Tank); the tank must then be emptied. remove the air exhaust hose (14). In the air-conditioning function, the unit employs an exclusive condensation recycling system to dispose of excess moisture. When the humidity is particularly high, an excess of condensation may built up in the TANK 9 . When this happens, the display will show the letters " " (Full Tank); indicating that the TANK should be emptied. Whenever conditions of high humidity make the problem recurrent, you may discharge the excess water directly into a drain, using the rubber tube supplied. The tube should be inserted into the hole provided, after having removed the rubber stopper. Make sure the TANK is put back correctly otherwise the display will continue to show the letters " " 11 ENGLISH Operation pac160 GB 25-01-2003 10:19 Pagina 12 Operation Once the dehumidifying function has been selected, the fan speed cannot be changed. "Silent" speed VENTILATION Adjust the fan speed by pressing the "FAN" (Q) button, as illustrated in the air conditioning function. Bear in mind that the higher the speed, the greater the volume of air filtered; by selecting the "Silent" speed, less air is filtered, but the noise level is low. [. . . ] This warranty shall apply only if the AIR-CONDITIONER is used in accordance with the factory directions which accompany it, and on Alternatign Current (AC) circuit. This warranty is in lieu of all other warranties and representations, expressed or implied, and all other obligations or liabilities on our part. We do not authorize any other person or company to assume for us any liability in connection with the sale or use of our AIR-CONDITIONER. [. . . ]