User manual DELONGHI HR 720

[. . . ] Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below. Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might find it and plug it into a supply socket - with the obvious consequent danger. [. . . ] If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. ASSEMBLING THE FEET To fit the feet to the appliance, proceed as follows: Insert the foot ensuring that the bigger hole A on the foot coincides with the screw mounted on the base of the convector (see figure 1); then screw in the remaining three screws (see figure 2) which are supplied. ELECTRICAL CONNECTION - Before inserting the plug into an electrical outlet, check carefully to be certain that the voltage in your home's electrical system matches the voltage (V) indicated on the appliance and that the socket and mains feed are sufficient to power the appliance. OPERATION AND USE TURNING ON Plug the appliance into the mains socket and turn the thermostat knob to maximum. ADJUSTING THE THERMOSTAT When the room has reached the desired temperature, turn the thermostat knob slowly in an counterclockwise direction until you hear a click and the appliance turns off (indicator light off). The thermostat will now keep the temperature in the room constant, turning the heater on and off as appropriate. MAINTENANCE Always unplug from the mains socket and allow to cool down before cleaning the appliance. This electric heating convector does not require any special maintenance. All you have to do is dust it off with a soft, dry cloth ­ but do so only when the appliance is cool. WARNINGS ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. ⷠDo not make use of this heating convector in the immediate proximity of bathtubs, showers, washbasins, pools, etc. In addition, this appliance must never be placed directly under a permanent electrical outlet. ⷠDo not rest the power cable on the appliance when it is hot. [. . . ] The use of extension leads is not recommended as they could overheat while the appliance is in use. Important: never cover this appliance in any manner whatsoever while it is operating. To do so would cause a dangerous increase in the temperature of the appliance itself. [. . . ]