User manual DELONGHI HIR 2

[. . . ] This appliance MUST NOT be used in basements, high rise flats, bathrooms or bedrooms and in rooms having volume less than 15 m3 (30 m3 in living rooms). This appliance emits the combustion residues in the room in which is used. DO NOT place clothes or other materials on the heater, as apart from the danger of fire their presence could affect the efficient working of the appliance (fig. [. . . ] 6 push the front panel assembly forwards as far as the tabs will slide in their slots to align the screw holes "A" in the base plate with the screw holes "D" Holes D in the bottom of the front panel assembly. 3) Fit the front panel assembly to the base plate by fixing the two screws (fig. 7) (removed previously) trough the aligned screw holes (holes D and A). Place the gas cylinder in the gas cylinder compartment and connect the regulator to the cylinder as shown on page 4. Slot C Screw fig. First, engage the two clips located on the top cover, in order to bend the panel and fix it into shape. Then insert the six tabs in the six slots at the rear of the heater body Attention: to unhook press on the relevant clips (fig. 8). clip Lower cover Clip Tabs Top cover Lower cover Tabs fig. 8 3 GB 21-07-2003 16:05 Pagina 4 GENERAL SAFETY INSTRUCTIONS Gas bottle Gas Bottle with 15 kg of maximum capacity can be installed. Changing of gas bottle must not be carried out in the presence of a naked flame. If a screw on regulator is used ensure that the regulator washer is present and in good condition -replace if in any doubt. To place the bottle in position, remove the rear panel which faces the inside during transport, by unfastening the screws; than put the bottle in position and replace the panel. Do not turn the bottle upside down to use completely its content. Pressure regulators, rubber tubes and clips CHECK that tubing is completely over the nozzles at each end of the tubing and that it is held firmly in place by tube clips (See fig. 9). Examine flexible tubing regularly and get your Dealer to fit new tubing 400 mm long complying to local standard, if perished, worn or damaged. 9 When connecting the pressure regulator to the gas bottle avoid undue twisting of the flexible tubing. A 28 ÷ 30 mbar (11. 2 in w. g. ) pressure regulator for Butane or Propane complying to local standard must be connected to the appliance with the above tubing, using suitable tube clips. Ventilation USE ONLY IN A WELL VENTILATED ROOM Adequate ventilation must be provided in rooms in which the heater is used. This ensures removal of the products of combustion and allows the entry of replacement air. The following table shows the smallest size of room suitable for each heat setting and the dimensions of the aperture which must be provided equally divided between high and low level, according with the maximum, medium or minimum power. Room Size Room Aperture 42 m3 105 cm 2 Safety guard The guard is to prevent risk of fire and no part of it should be permanently removed. It does not give full protection for young children or the infirm. 4 GB 21-07-2003 16:05 Pagina 5 OPERATING INSTRUCTIONS Lighting the heater 1. [. . . ] Important When the large knob is released at the end of the ignition time (see the rating plate and instruction booklet), it must return upwards by around 5 mm to its initial position. If this does not happen, close the gas tap and contact your after-sales service centre. Never operate the appliance with the large knob held downwards by force. [. . . ]