User manual DELONGHI HCO 620

[. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] Adjusting the thermostat When the room has reached the required temperature, turn the thermostat dial (B) slowly anticlockwise until the lights go out and no further. The thermostat will automatically regulate the temperature set and keep it constant. In spring or autumn or on mild days, you can save energy by using minimum power. Frost prevention mode With the thermostat dial in the position and one of the power levels selected, the appliance maintains room temperature at about 5°C, preventing freezing with minimal energy consumption. Models with fan A number of models have a fan for faster more even heating. To use this function, turn the power selector (A) to the Max position (the corresponding light comes on). Models with 24 hour timer (C) To set the heating periods proceed as follows: • Check the time on your clock or watch. 00 for example, turn the numbered programmer disk until the number 10 coincides with the pointer ▲ marked on the programmer. € Set the periods of time during which you want the appliance to operate by pushing the teeth towards the centre. At the end of this procedure, sectors corresponding to the operating periods can be seen. € In this way, the appliance will function automatically each day at the times set. (Important: the appliance must always be plugged into the socket) 6 • To modify programming, return the teeth to the initial position and set the new operating periods. € To use the appliance without programming, push all the teeth into the centre. In this case, to turn the appliance off completely, turn the dial (A) to the “0” position and unplug from the mains to avoid the programmer operating uselessly. [. . . ] At bortskaffe et elektrisk husholdningsapparat separat gør det muligt at undgå eventuelle negative konsekvenser for miljø og helbred på grund af upassende bortskaffelse og det giver mulighed for at genbruge de materialer det består af og dermed opnå en betydelig energi- og ressourcebesparelse. I dette tilfellet er det nødvendig å vri bryter "A" i posisjon "0" for å slå av apparatet, og også fjerne kontakten for å unngå at tidsinnstilleren settes i gang unødig. VARNINGAR OBS: För att undvika fara till följd av att säkerhetssystemet oavsiktligen återställs bör strömförsörjningen till denna apparat inte ske via en extern timer. [. . . ]