User manual DELONGHI HCA 520FSBG

[. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] The appliance should not be installed immediately below a permanent mains outlet. Position the appliance so that the plug and the outlet can be easily reached even after installation. ELECTRICAL CONNECTION - Before inserting the plug into an electrical outlet, check carefully to be certain that the voltage in your home's electrical system matches the voltage (V) indicated on the appliance and that the socket and mains feed are sufficient to power the appliance. 5: please remember that the LEDs on the left indicate the selected output, while the LEDs on the right indicate the current output of the appliance. adjusting the thermostat Adjust the thermostat to the ideal temperature between (5°C) and MAX (35°C). When the room has reached the desired temperature, the appliance will maintain the temperature, cycling between maximum output (Pmax), medium output (Pmed), minimum output (Pmin) and OFF, as signalled by the switching on and off of the LEDs on the right. When set in this way, the appliance will switch on whenever the room temp falls below 5°C, avoiding excessive cooling with minimum energy consumption. Fan models A number of models have a fan for even more rapid and uniform heating. Let us imagine the time is 10 o'clock: turn the numbered disk of the timer in a clockwise direction until the number 10 on the disk coincides with the v reference index stamped on the timer. Set the time period that you want the appliance to operate for, pushing the teeth towards the centre. When set in this manner, the radiator will automatically operate every day during the time period set. (Important: the plug must always remain inserted into the electrical outlet). To change the timer settings, just bring the teeth back to their starting position and set the new operating periods. If you wish to operate the appliance without the timer, push all the teeth into the centre. In this case, in order to totally turn off the appliance, besides turning off the switches, it is necessary to remove the plug from the electrical outlet, in order to prevent the timer from operating unnecessarily. MAINTENANCE Always pull the plug out of its electrical outlet before beginning any cleaning. [. . . ] To reactivate it, remove the plug from the electrical outlet, allow the appliance to cool (about 5'), remove the cause of the overheating/draught and then reconnect the appliance to the mains and turn it back on. Important: never cover this appliance in any manner whatsoever while it is operating. To do so would cause a dangerous increase in the temperature of the appliance itself. [. . . ]