User manual DELONGHI HBP 742T

[. . . ] ONLY) A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. [. . . ] SWITCHING ON AND OFF PROCEDURE To switch on appliance, whatever the function desired, put timer lever to position for continuous operation, or to position for "programmed" operation (see Timer section). SELECTOR KNOB - Position A: Setting for hair dryer function - Position B: Setting for hair dryer function + Heating at 1000 W without thermostat - Position C: Heating at 1000 W without thermostat - Position D: Heating at 2000 W with thermostat on maximum - Position E: Anti-freeze function (appliance maintains room temperature at about 5°C, preventing freezing with minimum energy consumption). THERMOSTAT REGULATION To regulate room temperature, proceed as follows: - Put selector knob to position D; - Wait for room temperature to reach comfort level desired, then slowly rotate selector knob clockwise until warning light goes off. the temperature thus set will be automatically maintained by the thermostat. Should further temperature adjustment changes be required, turn knob clockwise to lower the temperature and counter clockwise to raise it. TIMER For programmed function, appliance must be constantly connected to power supply. , turn numbered dial of timer clockwise until number 18 is aligned with pointer v on timer. To change programmed operating times, just push teeth back to original position and reset timer for new functioning period. - For use of appliance, outside preset timer programme, just put timer lever to position . hAIR DRYER Put timer lever to and selector knob to position A (also B = dual function). Hair dryer works at 500 W with switch on handle set on position I ; at 1000 W on position II . WARNING - This apparatus and the hair dryer come with a Y-type connection. The electrical feed cord must When the appliance is used as a portable heater, do not place it close to walls, furniture, curtains etc. never obstruct the intake and outlet grilles (danger of overheating). The heater must positioned at least 50 cm from furniture or other objects. Do not at any time place hair dryer in its storage space while still in use. [. . . ] För att återställa funktionen, är det nödvändigt att placera timervisaren i läge "0" för några minuter, avlägsna orsaken till överhettningen och därefter föra tillbaka timervisaren till funktionsläget. Do not use hair dryer while in bath, under the shower or standingover washbasin with water in it. The heater must not be located immediately below a fixed socket-outlet. [. . . ]