User manual DELONGHI HBP 553

[. . . ] - THIS APPLIANCE COMPLIES WITH EEC DIRECTIVE 89/336, RELATING TO ELECTROMAGNETIC COMPATIBILITY. - When you plug in the appliance, the red pilot light will illuminate (Fig. INSTALLATION The appliance requires no installation; it should be used solely as a portable appliance on an horizontal surface. [. . . ] By turning the thermostat dial the display will show the selected temperature. In addition, the smaller characters on the right-hand side of the display will indicate the actualroom temperature (see figure) MAN C set temperature room temperature This heater has Electronic Climate Control which automatically monitors and selects the ideal power setting to maintain your chosen temperature. If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heat the room until it reaches the selected temperature. The unit will automatically maintain the temperature at a constant level, by switching between maximum, medium and minimum power. If the room temperature exceeds the selected temperature level, the appliance will switch off. The appliance will switch on automatically again when the room temperature falls below the selected temperature level. If medium power level has been selected using the "MANUAL FUNCTION" button, the appliance will modulate between medium and minimum power to maintain a selected temperature. FROST STAT FUNCTION Press the "MANUAL FUNCTION" button and it is recommended to select the maximum power level. Set the thermostat dial to the " " position (Fig. The display will show 5C (see figure below). When set in this way, the appliance will switch on automatically only if the room temperature falls below 5C, to prevent freezing, at minimum energy consumption. N. B. This function is not guaranteed in the event of power failures, lasting more than 2 minutes. MAN C 4 PROGRAMMING THE ELECTRONIC TIMER The timer allows you to set 2 programmes in a 24 hour period to programme the timer. The yellow timer ON lamp will light up. spia accesa AUTO MAN C O Fig. 4 2 Set the start time for your programme by pressing the "hour button" to set the hour and the "min" button to set the minutes. 3-To select how long you require the heater to be on, push button " " and push repeatedly until your chosen operating timespan appears. The time periods you are able to choose from are (15', 30', 45', 1hr, 2hr, 4hr (max). : O O : AUTO C 4- To set programme B, press the " AUTO" button again and then proceed as above to select the start hours and minutes. When the operating time is changed, the time of both programmes is updated 5-- Use the thermostat dial to set the desired comfort temperature, as described above. 6-When set in this way the appliance will automatically switch on at the set time and automatically maintain the preset comfort temperature. To cancel a programme, press the " AUTO" button and then the "hour " and "min" buttons until the display shows (see Fig. ) : TIMER OVERRIDE To operate the appliance without using the programmes (timer), press the "MANUAL FUNCTION" button (Fig. 1). IMPORTANT: If the heater looses its electricity supply for more than 2 minutes the appliance does not switch on. The display shows the blinking numbers. 5 MAINTENANCE - Always unplug the appliance from the electrical outlet before beginning any cleaning operations. [. . . ] - The appliance must be installed so as the switches and other controls are out of the reach of persons in the bathtub or shower. If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk. - Do not cover the appliance during operation, to prevent the risk of fire. [. . . ]