User manual DELONGHI HBM 12

[. . . ] ONLY) A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. [. . . ] If it is installed in a bathroom, the fan must be positioned outside the protection volume shown in fig. 4 in order to guarantee that the controls are not accessible to anyone using the bath or shower; · 3) and fix it by turning the screw in the upper part of the bracket in a clockwise direction with a screwdriver before completing the clamping with the anchoring screws in the lower part. eLECTRIC CONNECTION · Before fitting the plug in the mains socket, make absolutely sure that the voltage of your mains electricity supply is the same as the value in V shown on the heater. This appliance complies with EEC Directive 89/336, relating to electro-magnetic compatibility. 2000W heating: Turn the knob to position 2 When the room has reached the temperature desired, set the thermostat by slowly turning the thermostat knob counter-clockwise until you hear the click which switches off the heater. The temperature set in this way will be automatically maintained at a constant level by the thermostat. When the fan heater has been set in this way it will automatically come on whenever the temperature in the room falls close to five degrees and the room wil thus remain at a temperature of a few degrees above zero. The fan only will be switched on when the fan heater has been set in this way. Turning off the Appliance In order to turn the appliance off, turn the function and thermostat selector knob to position "O" (fig. If the appliance is not used for long periods it is advisable to disconnect the plug from the power socket. It is advisable to use only this power setting in order to dry hand-towels or other linen, particularly if they are of delicate material. ⷠWhen the appliance is not used for the drying function, the arm may be moved to rest position by pulling the release slider and turning it downwards. important Be careful not to overload or force the hand-towel holder arm. The appliance is equipped with a special arm release device (if the latter is overloaded) which makes it automatically drop to the vertical rest position. [. . . ] ⷠNever direct the fan heater's air flow towards furniture, curtains, spray cans and inflammable material. ⷠIf you need to replace the power supply cable, only ever use H05VV-F type cable with a crosssection area of 2x1 mm2. ⷠNever cover the appliance while it is operting, to avoid any risk of fire. [. . . ]