User manual DELONGHI FAN HEATER HMH550-3R

[. . . ] To wall-mount, proceed as follows: Drill holes in the wall, as shown in Fig. 1, paying particular attention to the minimum distances indicated. Hang the applince on the wall and fasten it using the third screw at the bottom. The appliance must not be positioned directly underneath a fixed power point. [. . . ] To turn the oscillation on press the footswitch at the front of the heater. To stop the heater in a particular position, simply press the footswitch again. The heater can also be tilted manually on its base to vary the airflow up and down. Please note: This heater is fitted with a tip over switch, which turns the heater off should it be accidentally knocked over. To restart the heater, simply place it upright again. GB. qxd 6-08-2003 10:20 Pagina 5 Fig. 4 MODELS WITH REMOTE CONTROL Some models are equipped with a remote control to provide ease of operation. Two AAA 1, 5V batteries are required (not included): · remove the cover located on the back side of the remote control; · insert the two AAA 1, 5V batteries positioning them correctly (see the instructions in the batteries compartment); · replace the cover. REMOTE CONTROL OPERATION - When you press the "ON power selection" push button, the appliace operates at the maximum power. With each further press of the "power selection" push button, the power will change from MAX to MED/MIN/MAX. - If you want to operate with the fan only, press the "Fan Only" pushbutton. - Only when a function is selected it is possible to activate the oscillation of the appliance, by pushing the "ON/OFF oscillating base" push button. Every time you press a button, the appliance will confirm the selection with a "beep" and the pilot light on the remote control will illuminate. Pilot light Off ON power selection pushbutton Fan Only pushbutton ON/OFF oscillating base pushbutton MAINTENANCE - Before cleaning always switch off and remove the plug from the elettrical socket. - Periodically clean the air intake and outlet grilles during the period in which the heater is in use. A soft dry cloth should be used to clean the surfaces of the heater. GB. qxd 6-08-2003 10:20 Pagina 6 WARNINGS - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - The heater must be positioned at least 50cm from walls, curtains, furniture or other objects. - If the power cable is damaged, it must be replaced by the manufacturer or an authorised technical service centre. - Do not use this appliance in rooms which have a floor area smaller than 4m2 as this may lead to overheating. [. . . ] With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ]