User manual DELONGHI FAN HEATER HBP552-3B

[. . . ] WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ] By turning the thermostat dial the display will show the selected temperature. In addition, the numbers on the right-hand side of the display will indicate the actual room temperature as below. MAN °C selected temperature room temperature This heater has Electronic Climate Control which automatically monitors and selects the ideal power setting to maintain your chosen temperature. If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heat the room until it reaches the selected temperature. The unit will automatically maintain the temperature at a constant level, by switching between maximum, medium and minimum power. If the room temperature exceeds the selected temperature level, the appliance will switch off. Note: The display will always show the power setting you have chosen, not the one it is currently working at. The appliance will switch on automatically again when the room temperature falls below the selected temperature level. If medium power level has been selected using the "MANUAL FUNCTION" button, the appliance will modulate between medium and minimum power to maintain a selected temperature. FROST STAT FUNCTION Press the "MANUAL FUNCTION" button (it is recommended to select the maximum power level). 4 5714005700 HBP552. 3 30-10-2001 12:21 Pagina 5 Set the thermostat dial to the " " position (Fig. When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, thereby preventing freezing at minimum energy consumption. If the temperature in the room falls below 5 °C the room temperature display will show "LO". This function is not guaranteed in the event of power failures, lasting more than 2 minutes. MAN °C * PROGRAMMING THE ELECTRONIC TIMER The timer allows you to set 2 programmes in a 24 hour period. Set the start time for your programme by pressing the "hour button" to set the hour and the "min" button to set the minutes. To select how long you require the heater to be on, push button " " and repeatedly until your chosen operating timespan appears. The time periods you are able to choose from are (15', 30', 45', 1hr, 2hr, 4hr (max)). AUTO AUTO AUTO °C : O O : Display when setting Programme B Display when setting Programme A Display when setting for 45 min operating time 4. To programme a second time period (programme B) press the " AUTO" button twice and proceed as above. (Note: The operating period must be the same as in programme A, if the operating time is changed eg. Now set the comfort temperature as previously described by using the thermostat dial. The power level will automatically be set to maximum and will reduce to the lower power levels as required. The heater will switch on automatically every day at the preset time for the designated time period and will automatically maintain the selected confort temperature. [. . . ] - The appliance must not be positioned directly underneath a fixed power point. - Do not cover the appliance while it is functioning in order to avoid overheating with the attendant risk of fire. - The use of an extension lead is not reccommended, as overheating of the extension lead may occur during the operation of the heater. The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (eg. [. . . ]