User manual DELONGHI EW0507

[. . . ] Extreme caution should be taken when leaving an operating heater unattended near children or handicapped persons. Do not operate your heater when its cord or plug has been damaged or after it has malfunctioned, has been dropped or damaged in any manner. If you notice any leakage of oil, switch it off immediately and contact a service center as indicated in these instructions. Return the heater to an authorized service facility for inspection, electrical or mechanical adjustment, or repair. [. . . ] It is normal for the appliance to emit small cracking sounds when you turn it on for the first time. CAUTION: To prevent electric shock match wide blade of plug to wide slot, fully insert. SAVE THESE INSTRUCTIONS 2 GB-E 13-01-2004 14:26 Pagina 3 HOW TO USE YOUR HEATER FITTING THE WHEELS Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. Turn the radiator back to its upright position. fig. 1 BE CAREFUL Operate the heater in upright position only (wheels on the bottom, controls on the top). Watt switches may be used individually, after unit has reached the operating temperature. ON/OFF Switches Pilot lights 800 700 WATTS WATTS BOTH 1500 WATTS With pilot lights ON, the heater is ON! 1. LOCATION Place heater on the floor beneath the coldest window in the room, or any other location. Do not use this radiator in rooms with a floor area of less than 43 square feet (4 sq. CONNECTION The radiator should be connected to a properly polarized A/C 110/120 V household outlet in perfect working conditions. Keep loose clothing or bedding, furniture and flammable material away from the heater's wall outlet. TURNING ON TWO-SWITCH MODELS Turn the thermostat clockwise to its maximum position. When room reaches the desired temperature, turn the thermostat knob counter-clockwise very slowly and carefully until you hear a click. This should set your heater to maintain the desired temperature by cycling on and off as required. (For timer instructions, see paragraph 5. ) Note: The heater normally requires about 15 minutes to reach the desired temperature. 3 GB-E 13-01-2004 14:26 Pagina 4 4. USE OF THERMOSTAT The thermostat operates according to room air temperature, rather than radiator temperature. Turning it counter-clockwise to smaller numbers would decrease the temperature; clockwise to greater numbers would increase the temperature. Antifreeze function Turn the thermostat dial to the position and push the switches on. The appliance will maintain a minimum room temperature of approximately 42°F (5°C), thus preventing freezing while conserving energy. In models that come with a timer, tabs must be set in the inward position. REMINDER To completely shut the heater off, ON/OFF switches must be set in the OFF position. UNITS WITH TIMER Clock setting The program/timer, as with all clocks, must be set to the correct time. (day zone), rotate the dial clockwise (following the direction of the arrow) until 9. 30 is aligned with the triangular pointer. IMPORTANT: DO NOT ROTATE CLOCK DIAL COUNTER-CLOCKWISE. The timer is in effect an electric clock and would only work while it is plugged into a power supply. When unplugged, the timer stops and must be later re-set. Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). [. . . ] This appliance has been built to last for many years of trouble-free service. In case of malfunction or doubt, do not try to repair the heater by yourself: this might increase the risk of fire and electric shock. Call your nearest Service Center (see attached list of Service Centers). 5 GB-E 13-01-2004 14:26 Pagina 6 LIMITED WARRANTY What Does This Warranty Cover?We warrant each appliance to be free from defects in material and workmanship. [. . . ]