User manual DELONGHI ESAM 3600

[. . . ] . 28 9 PREPARING ESPRESSO COFFEE WITH PRE-GROUND COFFEE (INSTEAD OF BEANS) . . 30 11 CHANGING THE QUANTITY OF HOT WATER 12 PREPARING CAPPUCCINOS (FROTHED MILK AND COFFEE) 13 PREPARING FROTHED MILK (WITHOUT COFFEE) . . 36 19 PROBLEMS THAT CAN BE RESOLVED BEFORE CALLING THE SERVICE CENTRE . 37 20 TECHNICAL SPECIFICATION . . 38 IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. [. . . ] Remove the hot water spout (fig 21) and attach the milk container to the nozzle, making sure the arrow on the container lid is lined up with the arrow on the control panel of the appliance (fig. 23 and then place a sufficiently large cup under the coffee and milk spouts (fig. The appliance displays: CAPPUCCINO and after a few seconds, the frothed milk is run off from the milk spout into the cup below. The appliance then grinds the beans, delivers the coffee and displays the "ready" message again. Sweeten to taste and, if desired, sprinkle the froth with a little cocoa powder. NOTE 1: While preparing the cappuccino, frothed milk or coffee run off can be interrupted by pressing button . NOTE 2: If you run out of milk while delivering frothed milk, remove the container and refill it. Then put it back in place and press the button to request a cappuccino again. NOTE 3: To ensure the milk frother is absolutely clean and hygienic, after making cappuccinos, clean the channels inside the milk container lid: · Place a recipient under the milk spout; · Press the button on the milk container lid down and hold down for at least 8 seconds (fig. The appliance displays: CLEANING After cleaning is complete, remove the milk container and place in the refrigerator. You should not leave the milk outside the refrigerator for more than 15 minutes. NOTE 4: To change the quantity of coffee or frothed milk delivered automatically into the cup, follow the instructions in section 14. 30 13 PREPARING FROTHED MILK (WITHOUT COFFEE) 1. Fill the container with the quantity of milk you want to prepare (fig. 19). The appliance displays: MILK FROTHING and after a few seconds, the frothed milk is run off from the milk spout into the cup below. After run off, clean the channels inside the milk container by pressing the button as described in the previous section (note 3). 14 CHANGING THE QUANTITY OF COFFEE AND MILK FOR CAPPUCCINOS The appliance is factory preset to automatically deliver 70 ml of frothed milk and 80 ml of coffee. Fill the container with milk up to the maximum level indicated on the container. Press the button for at least 8 seconds until the appliance displays: MILK FOR CAPPUCCINO PROGRAM QUANTITY Now release the button. Once the required quantity of milk has been run off, press the button again. You should not run off frothed milk for more than 3 minutes at a time. After a few seconds, the appliance runs off coffee into the cup and displays: COFFEE FOR CAPPUCCINO PROGRAM QUANTITY 5. Once the required quantity of coffee has been run off, press the button again. The appliance is now re-programmed with the new settings and displays: READY. 15 CLEANING AND MAINTENANCE Before performing any cleaning operations, the appliance must have cooled down and must be disconnected from the mains power supply. [. . . ] Select a milder taste or reduce the quantity of ground coffee, then run off the coffee again. Clean the inside of the appliance thoroughly, as described in section 15. 2 If the message is still displayed after cleaning, contact a service centre. · The inside of the appliance is very dirty. · GENERIC ALARM 19 PROBLEMS TO BE RESOLVED BEFORE CALLING THE SERVICE CENTRE If the appliance is not working and an alarm light is on, the causes of the malfunction can be identified and resolved by referring to section 18. If, on the other hand, no alarm light is on, run the following checks before calling the service centre. [. . . ]