User manual DELONGHI E SAM 2200. S

[. . . ] 21 1 2 3 4 Description of the appliance Safety warning Installation . . . . . . 24 4. 2 Filling the container with coffee beans 4. 3 Using the coffee maker for the first time 5 6 7 8 9 Preparing the coffee (using coffee beans) Adjusting the coffee grinder . . . . . . 26 Preparing espresso coffee with ground coffee (instead of beans) . . . . . . 28 Preparing cappuccinos (using steam) 10 Cleaning and maintenance . . . [. . . ] · · · · Fig. 19 Fig. 20 OPERATING INSTRUCTIONS 29 9 PREPARING CAPPUCCINOS (USING STEAM) · Fill a container with around 100 grams of milk for each cappuccino being prepared. When choosing the size of the container, remember that the volume will increase by 2 or 3 times. It is recommended to use partially skimmed milk at fridge temperature. · Prepare the espresso coffee as described in the previous paragraph, using sufficiently large cups. · When the light remains on steady and stops flashing, the temperature of the machine has reached the ideal value for making the steam (par. · Immediately after, within a maximum of two minutes (otherwise the machine automatically returns to the coffee function), dip the milk frother into the container of milk (Fig. 23), making sure not to immerse the line in relief on the milk frother (indicated by the arrow in Fig. 24) and turn the steam knob half a turn anticlockwise until it stops (Fig. To make creamier foam, dip the milk frother into the milk and rotate the container with slow movements from the bottom to the top (you are recommended to limit steam delivery to no more than two minutes at a time). · Once having reached the desired temperature, stop the steam by turning the steam knob clockwise until it stops (Fig. · Pour the frothed milk into the cups containing the espresso coffee prepared previously. The cappuccino is now ready (add sugar to taste and if desired, sprinkle the foam with a little cocoa powder). NOTE 1: : immediately after having prepared the cappuccino, once having pressed the steam button Fig. 13) to make coffee again, the machine is too hot to make coffee (the green and lights flash to indicate that the temperature is not suitable); simply wait around ten minutes for the machine to cool down a little. HINT: To cool it down more quickly, after having deactivated the steam function, open the steam knob and release some water from the milk frother into a container, until the green and lights stop flashing. Proceed as follows: · Release a little steam for a few seconds by turning the steam knob anticlockwise until it stops (Fig. 5). GB Fig. 21 Fig. 22 Fig. 23 Fig. 24 OPERATING INSTRUCTIONS 30 · With this operation, the steam spout discharges any milk that may be left inside. IMPORTANT: For reasons of hygiene, this operation should always be performed, so as to prevent the milk from remaining in the circuits inside the milk frother. With one hand, hold the cappuccino tube firm and with the other unscrew the cappuccino maker itself by rotating clockwise and extracting downwards (fig. Remove the steam nozzle from the delivery spout by pulling it downwards (Fig. Replace the steam nozzle by inserting it and vigorously turning it upwards into the steam spout. Replace the milk frother by pushing it upwards and turning it anticlockwise. · · · · · Fig. 25 10 CLEANING AND MAINTENANCE · Before performing any cleaning operations, the machine must have cooled down and must be disconnected from the mains power supply. [. . . ] If, on the other hand, no alarm light is on, run the following checks before calling the service centre. · CAUSE The cups have not been preheated. SOLUTION Heat the cups by rinsing them in hot water or leaving them to rest for at least 15 minutes on the cup warmer tray on the lid (see par. Heat the infuser by pressing the button before making the coffee (Fig. 14, see note 3, chapter 5). · The infuser is too cold · The machine uses too little cof- Turn the right-hand knob (Fig. [. . . ]