User manual DELONGHI ELECTRIC HEATING CONVECTOR HS20 2

[. . . ] Assembling the feet Fit the feet to the appliance as follows: - Insert the anchor pins into the slots and turn the foot until it clicks into position (fig. 2) Wall mounting Before drilling into any wall ensure no electrical cables are present in the area. Fix two brackets "A" following carefully the dimensions as indicated in figure 3. [. . . ] We suggest that on days when temperatures are not particularly cold, select minimum output to optimise savings on energy consumption. Adjusting the thermostat (where applicable) When the room has reached the desired temperature, turn the thermostat dial slowly in an anti-clockwise direction until you hear a click and the appliance turns off. The thermostat will now keep the temperature in the room constant, turning the heater on and off as appropriate. Frost protection function (only on models with a thermostat) Turn the thermostat dial fully anti-clockwise to the position. When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, to prevent freezing at minimum energy consumption. Model with a fan This version makes it possible to heat a room even more quickly, thanks to a built-in fan that speeds up the spread of heat and keeps the temperature uniform. To turn this unit on, proceed as follows: · Turn the thermostat knob clockwise to the last possible setting. · To operate the appliance at minimum without the fan, press the button of the left switch (the red area will become visible). · To operate the appliance at minimum with the fan, press the button of the right switch (the red area will become visible). · Push both switches in order to get the highest power In this model, the thermostat can be adjusted just as it is for models without a fan. 4 HS Cleaning and maintenance The convector should not require any maintenance. However before carrying out any cleaning or maintenance, unplug the heater from the mains and wait for it to cool (this should take around 5 minutes. If necessary, remove concentrated areas of dirt with a vacuum cleaner. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Do not block the outlet grilles at the top of the heater or the intake grille at the botton of the heater. - The heater must be positioned at least 50cm from furniture or other objects. - If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk. - Do not use this appliance in rooms which have a floor area smaller than 4m2. - We recommend that you do not place the heater in a draught as this may adversely affect the appliance's operational efficiency. - The heater must never be placed immediately under a fixed mains socket. - IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. [. . . ] In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. B) If your appliance is not fitted with a plug, please follow the instructions provided below. IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The blue wire must be connected to the terminal marked with the letter N or coloured black. [. . . ]