User manual DELONGHI EC 190

[. . . ] The manufacturer is not liable for damage caused by inadeguate earthing of the appliance. · In the event of incompatibility between the plug on the appliance and the socket, have the plug replaced with another of the right type by a qualified professional. · Never install the machine in an environment that can reach a temperature less than or equal to 0°C (if the water in it freezes, the coffee maker may be damaged). · When the machine is in operation, any additional cable can be stored in the machine by inserting it back into the cable supply outlet. [. . . ] If you press to light, coffee will come out too fast and cream will be a very light color. 7. To remove the used coffee, hold the filter locked with the special lever that is built into the handle and let the coffee fall out by knocking the overturned filter holder (Fig. 8. To switch off the coffee machine, turn the selector knob on the appliance to the OFF position "O" (fig. ATTENZION: The first time that coffee is prepared, it is necessary to wash all of the accessories and the internal circuits of the machine, preparing at least five coffees without using the ground coffee HOW TO PREPARE COFFEE USING THE FILTER HOLDER FOR PODS (if fitted): · Preheat the machine as described in the `Preheating the Coffee Machine' section, making sure to leave the filter holder attached to the unit. Following this procedure ensures that the coffee is delivered at a hotter temperature, as well as guaranteeing that the seal of the filter holder gaskets is more effective. · Press the filter holder button and insert the pod into the filter (fig 15). Always follow the instructions on the package of the wafers for the correct positioning of the wafer in the filter. Note: Use pods which conform to the ESE standard: this will be indicated on the packaging by the following symbol: The ESE standard is a system accepted by the leading coffee pod manufacturers, and allows espresso coffee to be prepared simply and without any mess. 3. Attach the filter holder onto the machine, moving from left to right (fig 6). IMPORTANT: Should the coffee holder for pods be used after one for ground coffee, it's necessary to clear the ground coffee remained in the espresso boiler outlet. This cleaning operation is necessary in order to avoid water leackeges from the coffe holder for pods whele coffee is being preposed. 4. Proceed as in points 4, 5 and 6 in the previous section on how to prepare espresso. 5. To remove the pod, press the button on the filter holder and simply lift the pod out 6. To turn the coffee machine off, turn the selector knob on the appliance to the Off position "O" (fig. 14). Note:to prepare the coffee after having frothed the milk, first let the boiler cool down, otherwise the coffee will be burnt. To cool the boiler down, place a container underneath the outlet, turn the selector knob to the "espresso" position and allow the water to flow out until the `OK' light goes off. Return the selector knob to the position and then prepare the coffee as described in the previous paragraph. IMPORTANT: always clean the milk frother and steam nozzle immediately after use. PRODUCING HOT WATER 1. urn on the coffee unit by turning the selector knob to the position (fig. 2. Position a container under the cappuccino maker; 3. When the `OK' pilot light comes on, position the selector knob at (fig. 8) and at the same time turn the steam knob in an anti-clockwise direction (fig. To stop the flow of hot water, turn the steam knob in a clockwise direction and position the selector knob at "O" (fig. 14). HOW TO MAKE CAPPUCCINO 1. Prepare espresso coffee, using cups that are large enough for cappuccinos (see "How to prepare espresso coffee). 16) Wait until the orange "OK" light comes on, to indicate that the boiler has reached the ideal temperature for producing steam. [. . . ] · Change the quality of ground coffee · Only use ground coffee for espresso coffee makers. · Rinse the unit as described in the "descaling" section. The espresso coffee is cold. · The `OK' pilot light was not on when the coffee delivery switch was pressed. · The preheating was not carried out ·The cups were not preheated The pump is too noisy. · The water tank is empty. · The tank is inserted wrongly and the valve at the bottom is not open. [. . . ]