User manual DELONGHI DS 105

[. . . ] If the plug is a moulded-on typer, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be based until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ] Keep hold of the rubber stopper: it can be used both for blocking the hose and for plugging the spout if the canister is used for discharging in the future (see point A). Fig. 3 Canister Control System This dehumidifier is equipped with a special intelligent device which checks that it is working properly. A warning lamp placed on the control panel comes on to warn the user when: 1. you are using the continuous discharge and there is a blockage in the hose or the hose goes "uphill" remove the blockage. Once the cause has been removed, the warning lamp goes off and the appliance starts working again. 13 Electrical connections Before connecting the appliance to the power supply, check the following: · The mains power supply must correspond to the power supply shown on the rating plate. · The power socket and the electrical circuit must be adequate to supply the appliance. The manufacturer accepts no responsibility if these safety regulations are not complied with. This appliance is manufactured in compliance with EEC directive EN 55014 relative to the suppression of radio interference. Description of the controls Humidistat knob Canister control system pilot lamp Using the dehumidifier 1) Plug the appliance into the power socket. 2) Check that the "Canister control system" pilot lamp is off. 3) Turn the humidistat knob to "CONTINUOUS" for continuous operation. 4) To switch off the appliance, turn the humidistat knob anti-clockwise to the "OFF" position. Note: For technical reasons, the humidity is expressed in levels rather than in degrees. We recommend starting with the humidistat knob set to "CONTINUOUS". When the humidity in the room reaches the desired level, turn the knob slowly anti-clockwise until the appliance switches off. In this way, the appliance is programmed to maintain the exact humidity level that you desire. When in its dehumidifying function the appliance not only dehumidifies but also heats the room slightly. The following use examples are given on the equipment's control panel: 14 To dehumidify an area that is not lived in, such as a cellar. To dehumidify rooms where low humidity is desired, such as the laundry room. Maintenance Always remove the plug from the power socket before performing any cleaning or maintenance operations. For safety, never use a jet of water to wash the appliance. Cleaning the cabinet · Clean the appliance using a damp cloth and dry using a dry cloth. [. . . ] · If the appliance requires repair, always contact a Service Centre authorized by the manufacturer. Repairs carried out by non-qualified personnel may be dangerous and render the warranty null and void. · Always remove the plug from the socket before performing cleaning or maintenance operations. [. . . ]