User manual DELONGHI DRAGON HM3

[. . . ] Do not operate the radiator if damaged. "Easy wheel"system Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. Fig. 1 Electrical connection - Before plugging the radiator into the mains, check that your supply voltage is the same as that shown on the rating plate of the radiator. - If using more than one appliance at a time, it is important to ensure that the ring main is adequate to cope with the power requirements. [. . . ] Once programmed in this way, the appliance will repeat the preestablished program every day, if the selector is in the position. 21 20 19 16 fig. 3 Timer override If you wish to override the timer settings, push the timer switch to position 1 (fig. 4) manual (timer override). To return to timed operation push the switch back to the middle position (fig. 4). I Manual (timer override) Timer operation fig. 4 0 Heater off NOTE: if the timer switch is at the 0 position (fig. 4), the heater is off and will not operate). Dragon HM3 3 GB 3-06-2004 11:27 Pagina 4 Cleaning and maintenance Your oil filled raditor is absolutely free from maintenance, fully reliable and will give many years of trouble free service. Wipe radiator with soft damp cloth; do not use detergents or abrasives. Important notes Do not use your radiator close to bath, wash-basin, shower and swimming pool. The heater must be positioned at least 50 cm from furniture or other objects. If the power cable has been damaged, it must be replaced by the manufacturer or the technical service centre or by a qualified person so as to avoid all risks. In order to eliminate the radiator's "new" smell, set it to maximum power for at least 8 hours when used for the first time. During this operation, the room in which the radiator is located must be ventilated. It is perfectly normal for the radiator to make "creacking" sounds when used for the first time. The radiator must not be located immediately below a fixed socket-outlet. The body of this radiator is filled with a precise quantity of special oil, so that repairs requiring the opening of the oil body must only be made by the service agent. Do not use this appliance in rooms having a floor area of less than 4m2 as this can lead to overheating. If the appliance is scrapped, provisions on the disposal of oil must be respected. The use of an extension lead is not recommended, as overheating of the extension lead may occur during the operation of the radiator. As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating your appliance, particularly in the vicinity of young children. - - - The appliance is fitted with a safety device which will switch off it in case of accidental overheating. To reset, disconnect the plug from the power for 30 minutes, remove the cause of overheating then plug the appliance in again. ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. [. . . ] Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. [. . . ]