User manual DELONGHI DH 250 R

[. . . ] PAG. P 63 64 65 66 67 68 69 69 69 70 70 70 71 71 72 SOMMARIO ALCUNE NOZIONI SULL'UMIDITA' . . . . . . . . . . . . . . PAG. I 33 34 35 36 37 38 39 39 39 40 40 40 41 41 42 PERIECOMENA Merkev" plhroforive" pavnw sthn ugrasiva . . . . . . Prodiagrafev" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . v Odhgive" egkatavstash" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the plug is a moulded-on typer, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. 4) There is a special pre-marked hole on the panel door of the appliance to allow the hose to pass through (fig. Before passing the hose through this hole, it is necessary to remove the central disk from the hole. Be careful to make sure the hose does not have to go "uphill", or the water will be left inside the canister. Keep hold of the rubber stopper: it can be used both for blocking the hose and for plugging the spout if the canister is used for discharging in the future (see point A). Fig. 3 Canister Control System This dehumidifier is equipped with a special intelligent device which checks that it is working properly. A warning lamp placed on the control panel comes on to warn the user when: 1. you are using the continuous discharge and there is a blockage in the hose or the hose goes "uphill" remove the blockage. Once the cause has been removed, the warning lamp goes off and the appliance starts working again. 8 Electrical connections Before connecting the appliance to the power supply, check the following: The mains power supply must correspond to the power supply shown on the rating plate. The power socket and the electrical circuit must be adequate to supply the appliance. The manufacturer accepts no responsibility if these safety regulations are not complied with. This appliance is manufactured in compliance with EEC directive EN 55014 relative to the suppression of radio interference. Description of the controls Minimum speed/economy heating pilot light: Indicates appliance is operating at minimum fan speed Dehumidifying pilot light: Indicates appliance in dehumidifying function Heating pilot light: Indicates appliance in heating function Maximum speed/maximum heating pilot light: Indicates appliance is operating at maximum fan speed Thermostat knob: For setting temperature to levels 1 - 5 Heating pushbutton: Switches heating function on and off Tank warning light: Indicates the tank is full, not in the correct position or not fitted Humidostat knob: Selects relative humidity percentage from 1 to continuous. Dehumidifying pushbutton: Switches dehumidifying function on and off Speed selection pushbutton: Selects the ECON (economy heating) or MAX (maximum heating) fan speed. Dehumidifier operation 1) 2) 3) 4) Plug the appliance into a mains socket. Set the humidostat to its "CONTINUOUS" position (continuous operation). (The dehumidifying pilot light will come on and the appliance will start operating. If the heating pilot light is on, press the heating pushbutton to switch the function off). 5) Select the maximum or minimum fan speed (the relevant pilot light will come on to indicate which speed has been selected). When the humidity in the room has reached the level desired, slowly turn the humidostat knob counterclockwise until the dehumidifying pilot light goes out. Your dehumidifier will then automatically keep the humidity in the room at the selected level. When in its dehumidifying function the appliance not only dehumidifies but also heats the room slightly. 9 Heating operation 1) Plug the appliance into a mains socket. (The heating pilot light will come on and the appliance will start operating. If the dehumidifying pilot light is on, press the dehumidifying pushbutton to switch the function off). = 800 W) heating power (the relevant pilot light will come on to indicate which power has been selected). [. . . ] The appliance must not be modified in any way, as any modifications may be extremely dangerous. If the appliance requires repair, always contact a Service Centre authorized by the manufacturer. Repairs carried out by non-qualified personnel may be dangerous and render the warranty null and void. Always remove the plug from the socket before performing cleaning or maintenance operations. [. . . ]