User manual DELONGHI DEHUMIDIFIER DEC14

[. . . ] 4. Control panel Control panel cover Air outlet grille Condensate collection tank Accessory 5. 8. Lifting handle Air intake grille Electrostatic filter (some models only) Air filter Accessory condensate drain hose (some models only) rubber bung Important Important · Use this appliance only as described in this instruction manual. As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible caution and common sense should be applied when operating and installing this air conditioner. · This appliance is designed to dehumidify domestic rooms and must not be used for other purposes. [. . . ] · The appliance must be installed in conformity with the relevant national legislation. · Do not obstruct the air intake or outlet. Techni El cal assistance Keep the list of Technical Service Centres and identify the Centre nearest you. ectrical connections After moving the appliance, wait at least an hour before turning it on again. Before plugging the appliance into the power socket, check that: · The mains power supply corresponds to the power supply indicated on the rating plate. · The power socket and electrical circuit are adequate for the appliance. If this is not the case, have the plug replaced by a qualified electrician; · The power socket must be adequately earthed; Failure to respect this safety rule absolves the manufacturer from all liability. This appliance is manufactured in compliance with EEC standard EN 55014 on the suppression of radio interference. · The cable must be replaced by approved service personnel only. 14 Installation ENGLISH Inst ructions for fitting the wheels 1) Make sure the appliance is unplugged from the mains and the tank is empty 2) Remove the rubber caps from the base of the appliance by pulling them out, using pliers if necessary (see Figure 1/1). 3) Fit the wheels by inserting the shafts into the holes (see Figure 1/2) Note: When performing these operations, make sure the appliance is not tilted over 45°; in any case, after fitting the wheels, wait at least one hour before using the appliance again. Installation Position the appliance in the room to be dehumidified: A free space of at least 50 cm must be left at the front of the humidifier, so as not to block the air outlet. A space of around 5-10 cm should be left at the rear of the appliance for aeration. Condensate can be drained in one of two ways: A) Draining into the tank The condensate can be drained directly into the tank located inside the appliance (fig. The tank can be easily removed and has a handle making it simple to carry and empty. 2 B) Continuous external draining If the appliance is to be operated for long periods of time but you are unable to empty the tank, you are recommended to use the continuous drain facility. drill bit or removing the precut section by pressing with a screwdriver or similar (Fig. For models without drain hoses supplied, we suggest you purchase a rubber hose around 1 m long, with an internal diameter of 9. 5 mm. 3) The condensate drain hose must under no circumstances slope upwards, otherwise the water may remain in the tank. You will need it to plug the hose or close the spout if you revert to draining into the tank (see point A). 4 NO YES YES 15 How to dehumidify How to dehumidify (Models with humidistat) 1) Plug the appliance into a mains socket. 2) Check that the "tank full/tank missing" light is off; if not, place the tank to the correct position. 3) The dehumidification standby light switches on in the first 3 minutes (safety device), after which the appliance starts dehumidifying. [. . . ] The light remains on only when the appliance is effectively dehumidifying; if the humidity in the room is already low enough, the light will be off. dification standby/low temperature operation light The light switches on in the following two cases: 1) To signal a delay of around 3 minutes in the start-up of the appliance. This device protects the compressor against too frequent starts and stops. When the room temperature is too low, the electronic low temperature operation device is activated. The device makes the appliance operate by alternating dehumidification cycles and fan only cycles, thus avoiding the formation of frost. [. . . ]