User manual DELONGHI DEC 12

[. . . ] · This appliance is designed to dehumidify domestic rooms and must not be used for other purposes. · In the case that the power cable becomes damaged, this must be substituted only by specialised personnel authorised by the manufacturer. · It is dangerous to modify or alter the characteristics of the appliance in any way. · If the appliance requires repair, always contact a Technical Service Centre authorised by the manufacturer. [. . . ] This appliance is manufactured in compliance with EEC standard EN 55014 on the suppression of radio interference. · The cable must be replaced by approved service personnel only. 14 Installation tion the appliance in the room to be dehumidified: A free space of at least 50 cm must be left at the front of the humidifier, so as not to block the air outlet. A space of around 5-10 cm should be left at the rear of the appliance for aeration. Condensate can be drained in one of two ways: A) Draining into the tank The condensate can be drained directly into the tank located inside the appliance (fig. The tank can be easily removed and has a handle making it simple to carry and empty. Posi fig. 1 B) Continuous external draining If the appliance is to be operated for long periods of time but you are unable to empty the tank, you are recommended to use the continuous drain facility. For models without drain hoses supplied, we suggest you purchase a rubber hose around 2m long, with an internal diameter of 9. 5 mm. 3) Make sure that the hose is not higher than the spout, otherwise water will remain in the tank; also check that the hose not is choked (Fig. You will need it to plug the hose or close the spout if you revert to draining into the tank (see point A). NO YES fig. 3 15 ENGLISH How to dehumidify How to dehumidify (Models with humidistat) 1) Plug the appliance into a mains socket. 2) Check that the "tank full/tank missing" light is off; if not, place the tank to the correct position. 3) The dehumidification standby light switches on in the first 3 minutes (safety device), after which the appliance starts dehumidifying. 4) The humidistat knob is used to adjust the humidity level as desired (MIN/MED/MAX). When the knob is on MIN, the dehumidifier will slightly lower the humidity in the room; on MAX, on the other hand, the appliance will considerably lower the humidity in the room. To dehumidify simply turn the humidistat to one of the positions available. Dehumidifying standby light /antifrost function "Tank full / no tank" indicator light Humidistat knob How to dehumidify (Models with humidistat and function knob) 1) Plug the appliance into a mains socket. 3) Select the or or the dehumidification standby light switches on in the first 3 minutes (safety device), after which the dehumidification light switches on. 4) The humidistat knob is used to adjust the humidity level as desired (MIN/MED/MAX). When the knob is on MIN, the dehumidifier will slightly lower the humidity in the room; on MAX, on the other hand, the appliance will considerably lower the humidity in the room. Then turn the humidistat to one of the positions available. Functions selector Humidistat knob "Tank full / no tank" indicator light Dehumidifying standby light /antifrost function Dehumidifying indicator light 16 How to dehumidify ENGLISH Dehumi difier functions , low consumption dehumidification Your appliance features 4 functions: air purification , comfort function , clothes drying . Turn the function knob anticlockwise to select the various functions, as desired. Puri Low fication function Ideal where dehumidifying is not required, but simply to filter the air using the electrostatic filter supplied. The filter also purifies in all the other dehumidification functions. consumption dehumidification function When the set humidity level in the room is reached, the appliance stops. In cases where dehumidifying is required, while reducing consumption and limiting noise. Comfort Dry function This is the function used to reach the desired comfort level (set on the humidistat) in the fastest time possible. function (clothes drying) Recommended when operating the appliance at maximum capacity, to remove large quantities of moisture (e. g. [. . . ] These could cause the paint to flake or plastic parts to warp. eaning the air filter If the filter is dirty, air circulation is compromised and the efficiency of the dehumidifying and air purifying functions decreases. It is therefore good practice to clean the filter at regular intervals. If the unit is used constantly or systematically, you are recommended to clean the filter once a week. · To remove the air filter, extract by pulling it as shown in fig. [. . . ]