User manual DELONGHI CTO 4003

[. . . ] Whenever it may be necessary to use such equipment, it is advisable to use only single or multiple adapters or extension cables which comply with the current safety standards, and make sure not to exceed the wattage limit of the adapter or extension cable. · If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. · The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin. CTO 4003 4 Electrical Requirements Before using this appliance ensure that the voltage indicat- this appliance must be earthed ed on the product corresponds with the main voltage in Green and Yellow to Earth your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B. S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below. Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of, (having removed the fuse) and not left where children might find it and plug it into a supply socket - with the obvious consequent danger. We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. Important: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: GREEN AND YELLOW BLUE BROWN EARTH NEUTRAL LIVE 13 amp Fuse Brown to Live Cord Clamp Warning Blue to Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. 5 CT04R Toaster BEFORE USING FOR THE FIRST TIME · Clip excess cord into the cord storage clips underneath the toaster. · As with all new heating elements, your toaster may emit a slight burning or `new' smell when it is first switched on. · To eliminate the `new' smell at the first use, operate the toaster on a medium setting without any without any bread inside. TO USE YOUR TOASTER · Make sure than the ON levers (B) are at the rest position. · Insert the slices of bread into the bread toasting slots (A) and lower the lever (B) until it is all the way down. Note: If the appliance is not connected to the electrical outlet, the lever (B) will not stay down. · When the toasting is finished, the lever returns to the rest position, raising the toasted bread slices at the same time. · If the bread is not sufficiently toasted, select a darker degree of toasting by turning the browning control dial (D). · The toasting can be interrupted at any time by pressing the Stop/Cancel button (I). [. . . ] · Do not insert other foods that may drip during the cooking process. In addition to making the cleaning procedure more difficult, these may cause fires. · Do not insert (by force) foods that are too big for the slots. · Do not insert forks or other utensils into the toaster in order to remove bread. As well as damaging the toaster, there is a high risk of electric shock. [. . . ]