User manual DELONGHI CT04R TOASTER

[. . . ] Note: if the toaster is not connected to the electrical outlet, the lever will not go all the way down. · If the bread is not sufficiently toasted, select a darker degree of toasting by turning the browing control dial, clockwise. · Never use the toaster without bread inserted, except for the first use. · Do not insert other foods that may drip during the cooking process. [. . . ] For best results use bread slices of even thickness, size and freshness. Select a lower setting if a) using stale bread (toasts more quickly than fresh bread). To remove smaller items such as muffins, crumpets and bagels the control lever can be lifted approximately 20mm above the starting position. To achieve even browning, we suggest a minimum of 30 seconds between each toasting to allow the control to automatically reset. CT04R Toaster 4 Cleaning and Maintenance · Before cleaning: remove plug, switch off at the mains and allow to cool. · To clean the inside, turn the toaster upside down over the sink and gently shake. · Empty the crumb tray regularly - see "Crumb tray" section on page 3. · Use a soft dampened cloth to wipe the outside of the toaster and dry with a soft, dry cloth. · DO NOT use any sharp or pointed articles for cleaning the inside as this will damage the heating element. · NEVER put metal objects or your fingers into the toasting slots. Safety Warnings · The appliance is exclusively for the use for which it has been manufactured. Any other use is to be considered inappropriate and therefore dangerous. The manufacturer cannot be held responsible for eventual damage caused by inappropriate, improper or irresponsible use and/or for repairs made to the product by unauthorised personnel. · After removing the appliance from the packaging, make sure that the product is complete and in perfect condition. · The plastic bag in which the appliance was packaged should be kept out of reach of children as it poses a suffocation hazard. · In order to remove the dust that may have accumulated on the appliance, simply dust it off with a soft cloth. · Before inserting the plug into the electrical socket, make certain: - The voltage of the socket corresponds to the value indicated on the information label, attached to the appliance. - The electrical socket is adequately earthed, the manufacturer declines any responsibility for the lack of observation of this norm. · In the case of incompatibility between the socket and the plug of the appliance, have it replaced by a qualified technician. The use of adapters, multiple socket units and/or extension cables is not recommended. Whenever it may be necessary to use such equipment, it is advisable to use only single or multiple adapters or extension cables which comply with the current safety standards, and make sure not to exceed the wattage limit of the adapter or extension cable. · When the appliance is plugged into the electrical socket and whilst switched on never place hands into the bread toasting slots. · Never allow the appliance to be used by children or used without adult supervision. 5 CT04R Toaster · Do not touch the appliance with wet or damp hands. · The areas surrounding the bread slots become very hot during use: operating the toaster should be carried out touching only the plastic controls. Do not use this appliance under or next to curtains or other combustible material. [. . . ] We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. Important: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: GREEN AND YELLOW BLUE BROWN EARTH NEUTRAL LIVE As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ]