User manual DELONGHI COFFEE MAKER ICM18

[. . . ] If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. WARNING - THIS APPLIANCE MUST BE EARTHED Green and Yellow to Earth 13 amp Fuse Brown to Live Cord Clamp Blue to Neutral Coffee Maker EC190/200 SAFETY WARNINGS · This machine is designed to "make coffee" and to "heat drinks": be careful to avoid scalding from the water and steam jets or by using the machine incorrectly. · Do not touch hot parts (steam and hot water tube, boiler outlet, areas in contact with the filter holder and the warming plate). [. . . ] · Check that the mains supply corresponds to the voltage on the appliance rating plate. Connect the appliance to a correctlyearthed power socket (minimum rating 10A) only. The manufacturer declines all liability for any accidents due to the incorrect earthing of the appliance. · Never install the machine in environments where the temperature may reach 0°C or lower (the appliance may be damaged if the water freezes). · If the power cable is longer than the distance required to reach the power socket, the extra length may be stored inside the machine by pushing the cable inside the corresponding opening. Coffee Maker EC190/200 CHLORINE FILTER (if fitted) The filter eliminates the taste of chlorine from the water. To install the filter, proceed as follows : · Remove the chlorine filter from the plastic bag and rinse it in tap water. · Lift the coffee lid, remove the filter holder from its housing by lifting it upwards (Fig. 1 · Open the filter holder by pressing the parts marked "PUSH", and carefully position the filter as shown in Fig. · Close the filter holder and replace it in its housing, pushing it fully down. · The chlorine filter must be replaced every 80 cycles, and always after six months of operation. HOW TO PREPARE THE DRIP COFFEE ig. · Fill the tank with fresh, clean water up to the level corresponding to the number of cups of coffee required (Fig. · Place the tank back in the coffee maker, pressing it lightly. The tank may also be filled without being removed, using the jug marked with the level indicators (Fig. 3 · In versions with a permanent filter, place the filter in the filter holder (Fig. 10 · Place the ground coffee in the filter, using the measuring spoon supplied, and level evenly (Fig. As a general rule, use a level measuring spoon of ground coffee (around 7 grams) for each cup (for example, 12 spoons to make 12 cups). The quantity of ground coffee used may, however, be varied according to personal taste. Use good quality, medium ground coffee, packaged for drip coffee makers. · Close the filter holder door and place the jug, with the lid on, on the warming plate, make sure it is placed in the centre. · Choose the desired flavour as indicated in the paragraph "How to choose the flavour". 9). The ON pilot light above the switch indicates that the coffee maker is in operation. · In the models with the 6/12 cup switch " " for drip coffee, if more than six cups are required, press the 6/12 cup switch " " (Fig. [. . . ] When cleaning the coffee maker, do not use solvents or abrasive detergents. Never immerse the coffee maker in water: it is an electrical appliance. 13 CLEANING THE FLAVOUR SAVER To clean the Flavour Saver more efficiently, it can be removed from the filter holder cone by pressing it lightly inwards (Fig. 14 If the water in your local area is hard, lime scale will form over time. These deposits may affect the correct operation of the appliance. [. . . ]