User manual DELONGHI CKT2013 TOASTER

[. . . ] Lowering of the carriage will continue until it reaches the bottom, then it will rise. During the selection phase (stand-by), if no button is pressed within two minutes, the flashing number disappears and the segments only are displayed (screen saver). When any button is pressed, the display returns to stand-by and the last selection made is displayed. 3 3 Fig. 1 CKT2013 Toaster Reheat function " " (reheating slices of bread toasted previously) · Place the slices of bread in the toasting slots and press the reheat button. You will hear a beep and the symbol " " appears on the display. · During the selection phase, the function can be cancelled by pressing the reheat button again. [. . . ] Unplug from the mains, turn the appliance upside down and shake gently to remove. Cleaning and maintenance · Before cleaning or maintenance, always unplug from the mains socket. · Do not use abrasive detergents as these could ruin the surface. · After using the appliance, always unplug from the mains and empty the crumb tray on the bottom of the toaster. · If a slice of toast remains stuck in the slot, unplug the toaster from the mains, turn upside down, and shake gently. · NEVER TOUCH ANY PART OF THE TOASTER WITH SHARP UTENSILS, ESPECIALLY INSIDE THE TOASTING SLOTS. In the event of malfunction, the toaster is fitted with a safety device to prevent damage to the lifting motor. If " E " appears on the display, take the toa Safety Warnings · The appliance is exclusively for the use for which it has been manufactured. Any other use is to be considered inappropriate and therefore dangerous. The manufacturer cannot be held responsible for eventual damage caused by inappropriate, improper or irresponsible use and/or for repairs made to the product by unauthorised personnel. · After removing the appliance from the packaging, make sure that the product is complete and in perfect condition. · The plastic bag in which the appliance was packaged should be kept out of reach of children as it poses a suffocation hazard. · In order to remove the dust that may have accumulated on the appliance, simply dust it off with a soft cloth. · Before inserting the plug into the electrical socket, make certain: - The voltage of the socket corresponds to the value indicated on the information label, attached to the appliance. 5 CKT2013 Toaster - The electrical socket is adequately earthed, the manufacturer declines any responsibility for the lack of observation of this norm. · In the case of incompatibility between the socket and the plug of the appliance, have it replaced by a qualified technician. The use of adapters, multiple socket units and/or extension cables is not recommended. Whenever it may be necessary to use such equipment, it is advisable to use only simple or multiple adapters or extension cables which comply with the current safety standards, and make sure not to exceed the voltage limit of the adapter or extension cable. · When the appliance is plugged into the electrical socket and whilst switched on never place hands into the bread toasting slots. · Never allow the appliance to be used by children or used without adult supervision. · The metal sides of the toaster and the areas surrounding the bread slots become very hot during use: operating the toaster should be carried out touching only the plastic dials and handles. Do not use this appliance under or next to curtains or other combustible material. [. . . ] We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. Important: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: GREEN AND YELLOW BLUE BROWN EARTH NEUTRAL LIVE As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ]