User manual DELONGHI CF 170

[. . . ] If the appliance requires repair, contact a Service Centre authorised by the manufacturer only. If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk. Do not allow children or unfit persons to use the appliance without adequate supervision. Before cleaning or maintenance operations, always unplug the appliance from the mains socket. [. . . ] · Fit the end of the hose 13 to the flange 11 GB as shown in fig. E. E MAX100 cm 30 cm MIN 35 c 30 cm C Proceed as follows: · Drill a hole in an outside wall or through a window pane. When the hose 13 is not fitted, the hole can be closed with the flange cap 12 . When installing the air conditioner semi-permanently, you should leave a door slightly open (as little as 1 cm) to guarantee correct ventilation. in the window pane 111 in the wooden kickboard of a French window D in the wall: you are recommended to insulate the section of wall using suitable insulation. Keep the air hoses as short and free of curves as possible to avoid constrictions. 17 Control panel THE CONTROL PANEL O P IL M H G Q N A B C D E F DESCRIPTION OF THE CONTROL PANEL A ON/OFF button B MODE selection button Air conditioning, dehumidifying, fan. C Fan speed selection button (HIGH/MED/LOW) D Timer button E Programmed operation increase temperature/time button F Programmed operation decrease temperature/time button G Display Displays the temperature values set and the programmed operating time H Timer in operation indicator light I/L/M Fan speed lights N Fan mode light O Air-conditioning mode light P Dehumidifying mode light Q Alarm light 18 Operation TURNING THE APPLIANCE ON Plug the appliance into the mains. Press the ON/OFF button (A) (when turned on, the air conditioner starts operating in the same mode as when it was turned off). Press the MODE button (B) until the indicator light corresponding to the required mode lights up: Light (O): air-conditioning mode Light (N): fan mode Light (P): dehumidifying mode GB AIR-CONDITIONING MODE Ideal for hot humid weather when you need to cool and dehumidify the room. To set operation of the appliance correctly, press the + (E) or - (F) buttons until the desired temperature is displayed. Then select the fan speed by pressing the FAN button (C) until the indicator light corresponding to the required fan speed lights up: HIGH: the air conditioner operates at maximum to reach the required temperature as rapidly as possible MED: reduces noise levels but still maintains a good level of comfort LOW: for silent operation The most suitable temperature for the room during the summer varies from 24 to 27°C. You are recommended, however, not to set a temperature much below the outdoor temperature. 19 Operation FAN MODE Adjust fan speed by pressing the FAN button (C) as described for the air-conditioning mode. If you select "LOW" speed, less air is filtered but the appliance is also less noisy. DEHUMIDIFYING MODE Ideal for reducing the humidity in a room without lowering or raising the temperature (spring or autumn, damp rooms, rainy spells, etc). In this mode, other speeds cannot be selected. PROGRAMMING THE TIMER The timer can be used to delay appliance start up or shut down. How to programme delayed start up · Plug the appliance into a mains socket and press the ON/OFF button (A), then select the required operating mode and other settings (temperature, fan speed, etc). · Press the ON/OFF button (A) again to place the appliance in standby mode. · Use the + (E) or - (F) buttons to set the number of hours delay before the appliance comes on. How to programme delayed shut down · Delayed shut down can be programmed in any operating mode (air conditioning / fan/ dehumidifying). · Use the + (E) or - (F) buttons to set the number of hours delay before the appliance goes off. At the set time, the air conditioner shuts down and remains in standby. Light (H) stops flashing. 20 Using the remote control unit (Certain models only) MODELS WITH REMOTE CONTROL · Point the remote control at the receiver on the air-conditioner. · The remote control should be handled with extreme care and respect. [. . . ] CLEANING THE AIR FILTERS To keep your air conditioner working efficiently, you should clean the dust filter every week of operation. Remove the filter as shown in figure F Use a vacuum cleaner to remove the dust collected on the filter. If it is very dirty, immerse in warm water and rinse a number of times. START OF SEASON CHECKS Make sure the power cable and plug are undamaged and the earth system is efficient. [. . . ]