User manual DELONGHI CC 80 IU

[. . . ] Do not use a cracked container or a container having a loose or weakened handle. Do not clean container with cleaners, steel wool pads, or other abrasive material. A short power cord is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord. Longer, detachable power supply cords or extension cords are available and may be used if care is exercised in their use. [. . . ] Pour it slowly into the boiler, first making sure that the "cappuccino" switch is off and that the steam knob is turned off (fig. When it is filled like this the boiler provides enough water for between 15 and 20 cappuccinos. ⷠWarning: if the boiler is filled while it is hot (for example when the water runs out while a cappuccino is being made) pour in only the amount of water shown above and NEVER TRY TO FILL THE BOILER UP TO THE MAX 170 g ­ 6 oz MARK (fig. ⷠNext close the boiler cap by turning it firmly in a clockwise direction. Note: for safety reasons it is not possible to unscrew the boiler cap while the boiler is hot as it turns without unscrewing; if you need to fill the boiler you should wait until the water contained in it has been completely used up or until the boiler has cooled down. Further Boiler Refills Further boiler refills must be carried out as described in the previous paragraph and ONLY when the water in the boiler has completely run out. preparing the Milk for Cups of Cappuccino · Before dispensing milk, the boiler must be preheated for 10 minutes. Therefore, press the "CAPPUCCINO" button before preparing coffee; doing so, the boiler will heat right up. ⷠPrepare the coffee as illustrated in the paragraph headed "PREPARING THE COFFEE" and pour about 2 fl. To make a cappuccino, pour into the tank milk which is neither boiling nor hot. With the tank filled to the "MAX" line, 2 or 3 cappuccinos can be made. Never exceed the little mark which is placed immediately above the word "MAX" (fig. 10) or the milk may continue to drip from the pipe after the cappuccino has been prepared. ⷠPlace the cup containing coffee under the milk tank pipe, check that the milk tank is firmly attached, wait for the "OK" pilot lamp (N) to come on, the turn the steam knob at leat a full turn counter-clockwise. The "frothed" milk will begin to trickle out of the milk tank pipe (fig. To avoid the milk splashing if small cups are used, the anti-spray hood should be fitted on the milk tank pipe (fig. To ensure that the milk froths properly, always close the steam knob and wait for the OK pilot lamp to come on between one cappuccino and the next. As soon as the tank is empty and the machine begins to puff, turn off the steam by turning the steam knob in a clockwise direction. ⷠThe following proportions are recommended in order to obtain a perfect cappuccino: 1/3 coffee, 1/3 hot milk and 1/3 frothed milk. Suggestion: to make a hotter cappuccino when more than one cup is required, it is better to pour one cup of coffee at a time before immediately filling it with frothed milk, rather than pouring all the cups of coffee at the same time first and then filling them with frothed milk. ⷠBefore switching the boiler off it is necessary to clean the red emulsifier, so that it does not become blocked by the milk when it solidifies: to do so, fill the milk tank with a little water and turn the steam knob. In this way the steam cleans all the holes and emulsifier pipes and empties the internal circuits of any traces of milk. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. If repairs become necessary or spare parts are needed, plase write to: De'Longhi America Inc. 800-322-3848 The above warranty is in lieu of all other express warranties and representations; All implied warranties are limited to the applicable warranty period set forth above. This limitation does apply if you enter into an extended warranty with De'Longhi. [. . . ]