User manual DELONGHI BAR42E

[. . . ] · Do not operate with a damaged cord or plug, or after the appliance malfunctions, or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment. · The use of accessory attachments or spare parts not recommended by the appliance manufacturer may result in fire, electrical shock or personal injury. · Do not let the cord hang over the edge of the table or counter, or touch hot surfaces. [. . . ] If you are unable to insert the plug fully into the outlet, try reversing the plug. The manufacturer will not be held responsible for any accidents that may occur due to 2. Place a cup under the boiler outlet and make sure that the filter holder is attached to the machine. Use the same cup in wich the coffee will be served in, so that it may be preheated. 3. Wait until the "ESPRESSO OK" pilot light turns on 7 (fig. Let the water exit until the "ESPRESSO OK" light goes off; then stop the delivery by pressing the coffee delivery switch again. 4. Empty the cup, wait until the "OK" pilot light comes on again and repeat the whole operation one more time. Use the following directions to prepare the coffee: HOW TO PREPARE ESPRESSO COFFEE WITH THE FILTER HOLDER FOR GROUND COFFEE 1. After carrying out the preheating of the machine as described in the preceding section, in order to make just one cup of espresso coffee, insert the 1-cup filter (the smaller of the two provided) into the filter holder (Fig. 8) and fill it with one level measuring spoon of ground coffee ­ about 7 grams (Fig. 9). If you wish to prepare two cups of espresso coffee, use the 2-cup filter (the larger of the two provided) and fill it with two less-than-level measuring spoons of ground coffee (about 6+6 grams). 2. Distribute the ground coffee uniformly and press it lightly with the tamper (Fig. 3. Remove any excess coffee from the filter holder rim and hook the filter holder onto the machine, as always, rotating it as far as it will go (fig. 20), let the steam come out for a few seconds, then close the knob with the tube thus extracted. FOR HYGIENIC REASONS, IT IS RECOMMENDED THAT THIS OPERATION ALWAYS BE CARRIED OUT SO AS TO PREVENT THE MILK FROM STAGNATING IN THE CIRCUITS OF THE COFFEE MAKER. · Lastly, to prevent the mild from solidifying, it is necessary to wash the milk tank immediately, as described below in the "Cleaning the milk foamer and tank" section. ATTENTION: the first time that the machine is used, it is necessary to wash all the accessories and internal circuits as follows: 1. For the espresso boiler: make at least five coffees without using any ground coffee (following the directions given in the HOW TO PREPARE ESPRESSO COFFEE). For the steam boiler: fill it with a water measuring container, close the cap and press the CAPPUCCINO button. After 5 minutes, turn the knob and let steam come out until completely empty (this should take about 15 minutes). NOTE: We suggest you used semi-skimed milk at refrigerated temperature. When the tank has been filled up to the MAX line, you can make 2 or 3 cappuccinos. Never fill the tank over the little notch that is located just above the MAX sign (fig. 16); if the tank is too full, the milk may continue to drip from the tube after the cappuccino has been made. · Before starting delivery of the milk, always wait until the `CAPPUCCINO OK' pilot light (fig. This light indicates that the ideal temperature has been reached for foaming the milk. CLEANING AND MAINTENANCE Before carrying out any cleaning or maintenance operations, turn off the machine, take out the plug from the mains and let the device cool down. CLEANING THE MILK-FOAMER The milk foamer must be cleaned immediately after every use. [. . . ] ·The tank is badly inserted and the valve at its bottom is not open. SOLUTION · Fill the water tank. · Clean as indicated in the "Cleaning the espresso boiler outlet" section. · Press the tank lightly so as to open the valve at its bottom. · Have the espresso boiler gasket replaced at an authorized servce center · Clean the holes in the spouts. [. . . ]