User manual DEI ORION RGC-1

[. . . ] INTRODUCTION The RGC-1 remote gain control is specifically designed for use with ORION amplifiers. The RGC-1 allows dashboard control to your current Orion amplifier or earlier XTR, XTR Pro or HCCA amplifier. Used on the first amplifier in a daisy-chain, it works as a remote pre-amp volume control. [. . . ] For Green color illumination, connect the GREEN wire to a +12 Vdc source and the RED wire to chassis ground. INSTALLATION Under Dash Mounting To mount the RGC-1 under the dash or in an area that cannot be drilled through to accommodate the control, use the supplied under dash mounting bracket. Find a suitable location which will not interfere with driving that is easy to reach. Mount the bracket in place using the 2 screws and secure the RGC-1 to the bracket as shown below. ©2004 Directed Electronics, Inc. 1 AC502 Nut Under Dash Mounting Bracket Label Nut Knob Screws In-Dash Mounting Note: There must be enough clearance behind the dash-panel before selecting the location to mount the RGC-1. Side in the control from the rear of the dash panel and place the trim label on the threaded shaft. Secure the control with the nut and mount the knob If there is no access to the back of the dash panel, drill a 3/4-inch hole in order to pass the entire RGC-1 through the hole from the front of the dash panel. Once the control is through the hole, the clip shown below is passed through the hole and slid around the threaded shaft of the control. Place the trim label on the threaded shaft and secure the control with the nut and mount the knob. AC502 Front Mount Nut Clip Dashboard Trim Panel Label Nut Knob AC502 Nut Dashboard Label Nut Rear Mount Knob 2 ©2004 Directed Electronics, Inc. ADJUSTMENT PROCEDURE 1. Set the gain controls of the amplifier according to the "Adjusting the Sound of Your System" in your owner's manual. The amplifier primary gain controls determine the maximum allowed output level that the amplifier. The amount of bass can be adjusted for the type of music and individual preference. This will void your warranty. ©2004 Directed Electronics, Inc. 3 Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. During this two year period, there will be no charge for this replacement PROVIDED the unit is returned to Directed, shipping pre-paid. If the unit is installed by anyone other than an authorized Directed dealer, the warranty period will be 1 year from date of purchase by the dealer as indicated by the date code marking of the product. [. . . ] ALL UNITS RECEIVED BY DIRECTED FOR WARRANTY REPAIR WITHOUT PROOF OF DIRECTED DEALER INSTALLATION WILL BE COVERED BY THE LIMITED 1 YEAR PARTS AND LABOR WARRANTY. Note: This warranty does not cover labor costs for the removal and reinstallation of the unit. BY PURCHASING THIS PRODUCT, THE CONSUMER AGREES AND CONSENTS THAT ALL DISPUTES BETWEEN THE CONSUMER AND DIRECTED SHALL BE RESOLVED IN ACCORDANCE WITH CALIFORNIA LAWS IN SAN DIEGO COUNTY, CALIFORNIA. © 2004 Directed Electronics, Inc. [. . . ]