User manual DE LONGHI BAR 8

[. . . ] A short power cord is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord. Longer, detachable power supply cords or extension cords are available and may be used if care is exercised in their use. If an extension cord is used, the marked electrical rating should be at least as great as the electrical rating of the appliance. The longer cord should be arranged so that it will not drape over the counter-top or table top where it can be pulled on by children or tripped over. [. . . ] 15), otherwise the machine could continue to drip milk from the tank pipe Fresh milk must be used which has not been boiled and above all which is not warm. Prepare the coffee as described in the paragraph headed "PREPARING THE COFFEE" from point 1 to point 10, using, however, only the amount of water needed to obtain 2 cups of cappuccino as prescribed in the table at the end of the text. Note that the amount of water needed to make 2 cups of cappuccino is greater than that required for 2 cups of normal coffee as it also necessary to produce the steam to emulsify the milk. The coffee selector (O) must be set to the position "2 MEDIUM". Allow the coffee to trickle into the carafe until it reaches the level 2 marked. WARNING: It is the level of the darker coffee which lies a little below the lighter-coloured cream rather than the level of the cream itself which has to match with line 2. This operation must be carried out with great care: if the level of the coffee should exceed line 2, there will no longer be enough steam left at the end to froth the milk. Set the coffee selector to "4 CAPPUCCINO": Position the cups containing the coffee one at a time under the milk tank pipe and wait for the "OK steam ready" pilot light to come on (Q, fig. The antisplash hood (S) should be inserted on the milk tank pipe (fig. Turn the steam knob in an anti-clockwise direction; the frothy milk will begin to come out of the pipe. In order to achieve good frothing and to avoid milk from splashing the steam knob needs to be turned fully round at least once. Continue the process until half the milk tank has been emptied before shutting off the steam by turning the knob in a clockwise direction. Also fill the 2nd cup by repeating the previous process until the whole milk tank has been emptied. WARNING: Always wait for the "OK steam ready" pilot light (fig. Immediately after preparing the cups of cappuccino, pour a little water into the milk tank and place the carafe under the milk tank pipe. WARNING: Even if it may seem pointless, it is essential for this process to be carried out every Time in order to empty the boiler completely of any residual water or steam which would otherwise prevent the appliance from working properly when it was next used. This operation also serves to clean all the holes in the emulsifier and to empty the internal circuits of any residual milk. Before carrying out any cleaning or maintenance work, disconnect the appliance from the electrical power supply by pulling out the plug. Cleaning the Milk Frother Remember to clean the milk frother after each use as follows: · Remove the milk tank by pushing the "PRESS" lever while at the same time pulling it upwards, and wash the tank with warm water (fig. 20), especially wash and clean with warm water the holes shown in fig. Once they have been cleaned, all the pieces must be reassembled correctly. Pay attention that the rubber mixer is firmly pushed down and the red emulsifier is pushed till you hear clic. [. . . ] Some states do not allow limitations on how long an implied warranty lasts, so the above exclusions connection with the sale or use of its Espresso Coffee Machine. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. All DE' LONGHI electrical appliances are guaranteed to be free from defects in material and workmanship. Our obligation under this warranty is limited to the replacement or repair, free of charge, at our factory or authorized Service Centers, of any defective part or parts thereof other than parts damaged in transit, which shall be returned to us, transportation pre-paid, within one year from the date of delivery to the purchaser/user. [. . . ]