User manual DANA 4900-6

[. . . ] Make sure that the washing machine has not been damaged during the transportation process. If it has been damaged, contact the retailer and do not proceed any further with the installation process. Remove the 4 protective screws (used during transportation) and the rubber washer with the corresponding spacer, located on the rear part of the appliance (see figure). Connect the supply pipe by screwing it to a cold water tab using a ¾ gas threaded connection (see figure). [. . . ] To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle. The DOOR LOCKED indicator light will switch off, indicating that the door may be opened. Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. 5 Wash cycles Table of wash cycles GB Wash cycles Description of the wash cycle Max. Load (kg) Cycle duration 1 2 2 3 4 4 5 6 6 7 8 9 Silk/Curtains: for garments in silk and viscose, lingerie. Mix 15’: to refresh lightly soiled garments quickly (not suitable for wool, silk and clothes which require washing by hand). Shirts 90° 60° 40° 40° 60° 40° 30 90° 60° 40° 40° 30° 40° Cold Water Cold Water Cold Water - 1200 1200 1200 1200 800 800 800 1200 1200 800 600 0 600 1200 800 800 1200 1200 0 8 8 8 8 4 4 1, 5 8 8 4 2 2 2 8 3 3 8 8 8 For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 60456: set wash cycle 6 with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle 2 with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle 3 with a temperature of 40°C. Specials wash cycles Mix 15’(wash cycle 5) this wash cycle was designed to wash lightly soiled garments quickly: it lasts just 15 minutes and therefore saves both energy and time. By selecting this wash cycle (5 at 30°C), it is possible to wash different fabrics together (except for wool and silk items), with a maximum load of 1. At the end of the cycle the washing machine will perform slow rotations of the drum; the EASY IRON and START/PAUSE indicator lights will flash (orange) and the phase will remain lit in a fixed manner. To end the cycle, press the START/PAUSE button or the EASY IRON button. For the Silk wash cycle, the machine will end the cycle while the laundry is soaking, the EASY IRON and START/PAUSE indicator lights will flash (orange) and the RINSE phase will remain lit in a fixed manner. To drain the water so that the laundry may be removed, press the START/PAUSE button or the EASY IRON button. This function may not be used in conjunction with wash cycles 5, 6, 7, 10, 11, 12, 13, B. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the washing machine performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. Bleach cycle Bleaching may only be performed in conjunction with wash cycles 2, 3, 6. Preparing the laundry • Divide the laundry according to: - the type of fabric/the symbol on the label. - the colours: separate coloured garments from whites • Empty all garment pockets and check the buttons. [. . . ] Sometimes, small items (such as coins or buttons) may fall into the prechamber which protects the pump, situated in its bottom part. Using a screwdriver, remove the cover panel on the lower front part of the washing machine (see figure); Cleaning the washing machine The outer parts and rubber components of the appliance can be cleaned using a soft cloth soaked in lukewarm soapy water. Cleaning the detergent dispenser drawer 1 Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. [. . . ]