User manual DAHON SPEED DIAL ULTIMATE INSTALLATION

[. . . ] FRONT BRAKE INSTALLATION 1 INSTALL THE LEVER IMPORTANT! Black Ops Research TM SPEED DIAL ULTIMATE ® Installation Instructions Only brakes designated for direct-pull levers such as the Single Digit Ultimate, Single Digit Ti, 7, 5 and 3 brakes can be used with Avid levers. If you have any questions concerning compatibility of levers and brakes, contact your profession bike dealer. [. . . ] After installation, adjust the knob for the exact brake feel that you want. 4 SET THE REACH If you have smaller hands, you can adjust the reach of the lever by adjusting the reach hex bolt. 5 SET ADJUSTING BARREL Before installing the cable, adjust the barrel adjuster about half way out. THEN turn the screw. Slot SDULT-0901 1 2 3 5mm ~ 6mm 6 TIGHTEN THE CABLE Hold brake pads against the rim and tighten the cable. Now, screw the barrel adjuster in until you get the right amount of brake pad-to-rim clearance (approx. 1 - 1. 5 mm per side). 7 TEST THE SYSTEM With two fingers, squeeze the brake lever firmly about a dozen times to ensure the cables are seated properly and operate smoothly. Re-torque if necessary. Tighten Cable Anchor Bolt to: Lever Removal LIMITED WARRANTY To remove the levers: 1. Slide the clamp sideways off the lever. 6 - 8 Nm (52 - 69 in lb) Pop the clamp off the bar. Be careful not to expand the clamp wider than the diameter of the bar. 3 Avid, LLC (Avid) warrants to the original consumer purchaser of every Avid product that the product shall be free from defects in workmanship and materials for a period of one (1) year from the original date of purchase. The sole remedy under this warranty is limited to, at Avid's sole discretion, repair or replacement of the defective product. This warranty only applies to the original consumer purchaser and is not transferable. THIS WARRANTY DOES NOT COVER normal wear and tear (including, without limitation, brake pad wear), or defects or failures that are related in any way to improper installation or follow-up maintenance, accident, abuse or neglect (including, without limitation, thread damage). Since Avid has no control over the product's final use, Avid also does not warrant the suitability of the product for specific riders and/or uses. IN NO EVENT SHALL AVID BE RESPONSIBLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, WHETHER BASED ON CONTRACT, WARRANTY, NEGLIGENCE, OR STRICT OR PRODUCTS LIABILITY, INCLUDING WITHOUT LIMITATION, PERSONAL INJURY DAMAGES, PROPERTY DAMAGE OR ECONOMIC LOSSES. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. ALL IMPLIED WARRANTIES, INCLUDING ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY LIMITED TO THE ONE (1) YEAR DURATION OF THIS WARRANTY. [. . . ] If you bars are undersized - as some bars are - we strongly reccomend that you replace them. If you must use the bars, you can shim the lever clamp by putting a layer of cloth tape on the lever body clamp seat and reinstalling. Cloth Tape Avid, LLC 2875 W Oxford Ave # 7 Englewood, CO 80110 USA tel 303. 762. 9353 fax 303. 762. 1133 Website: www. avidbike. com Email: tech@avidbike. com Avid, Speed Dial and Cam Split Clamp are trademarks of Avid, LLC [. . . ]