User manual DAHON SL-R440 TECHNICAL SERVICE INSTRUCTIONS

[. . . ] Do not use in a combination which causes brake operation to be obstructed. Tightening torque : 5 N·m {44 in. lbs. } Replacement of the shifting lever unit and indicator < Front > < Rear > < Front > Removal of the indicator Disassembly and reassembly should only be carried out when replacing the indicator. 5 mm Allen key 5 mm Allen key < Rear > Removal of the indicator Disassembly and reassembly should only be carried out when replacing the indicator. [. . . ] Operate lever (B) at least eight times to set the lever to the highest position. Indicator set screws Indicator Lever (B) Lever (B) < Front > To shift from a small chainring to a larger chainring When lever (A) is pressed once, there is a shift of one step from a small chainring to a larger chainring. Example: from intermediate chainring to largest chainring. Lever (A) initial position < Rear > To shift from a small sprocket to a larger sprocket To shift one step only, press lever (A) to the 1 position. To shift two steps at one time, Lever (A) initial position press to the 2 position. 1 2 4. After checking that the indicator needle is at the right edge, install the indicator as shown in the illustration. 4. After checking that the indicator needle is at the left edge, install the indicator as shown in the illustration. 1 : Shifts one sprocket E. x. : from 3rd to 4t 43 Technical Service Instructions SI-6FH0C To shift from a large chainring to a smaller chainring When lever (B) is pressed once, there is a shift of one step from a large chainring to a smaller chainring. If it does not operate correctly, re-install the indicator by while taking particular note of steps 3. If it does not operate correctly, re-install the indicator by while taking particular note of steps 3. and 4. Replacement of the shifting lever unit Disassembly and reassembly should only be carried out when replacing the shifting lever unit. Loosen the cable fixing bolt (nut) of the front derailleur, and then pull the inner cable out of the shifting lever unit in the same way as when installing the inner cable. Remove the three shifting lever mounting screws, and then remove the shifting lever unit as shown in the illustration. Tightening torque : 0. 5 - 0. 8 N·m {4 - 7 in. lbs. } Replacement of the shifting lever unit Disassembly and reassembly should only be carried out when replacing the shifting lever unit. Loosen the cable fixing bolt (nut) of the rear derailleur, and then pull the inner cable out of the shifting lever unit in the same way as when installing the inner cable. Remove the three shifting lever mounting screws, and then remove the shifting lever unit as shown in the illustration. Tightening torque : 0. 5 - 0. 8 N·m {4 - 7 in. [. . . ] Do not turn it any further than this, otherwise it may damage the screw thread. Tightening torque: 0. 3 - 0. 5 N·m {3 - 4 in. lbs. } Inner hole cover Install the inner hole cover by turning it as shown in the illustration until it stops. [. . . ]