User manual D-LINK DWR-730

[. . . ] Preface D-Link reserves the right to revise this publication and to make changes in the content hereof without obligation to notify any person or organization of such revisions or changes. Trademarks D-Link and the D-Link logo are trademarks or registered trademarks of D-Link Corporation or its subsidiaries in the United States or other countries. All other company or product names mentioned herein are trademarks or registered trademarks of their respective companies. This publication may not be reproduced, in whole or in part, without prior expressed written permission from D-Link Systems, Inc. [. . . ] D-Link DWR-730 User Manual 37 Section 5 - Connecting to a Wireless Network Connect to a Wireless Network Using Windows® XP Windows® XP users may use the built-in wireless utility (Zero Configuration Utility). If you are using another company’s utility or Windows® 2000, please refer to the user manual of your wireless adapter for help with connecting to a wireless network. Most utilities will have a “site survey” option similar to the Windows® XP utility as seen below. If you receive the Wireless Networks Detected bubble, click on the center of the bubble to access the utility. Or Right-click on the wireless computer icon in your system tray (lower-right corner next to the time). The utility will display any available wireless networks in your area. Click on a network (displayed using the SSID) and click the Connect button. If you get a good signal but cannot access the Internet, check the TCP/IP settings for your wireless adapter. Refer to the Networking Basics section in this manual for more information. D-Link DWR-730 User Manual 38 Section 5 - Connecting to a Wireless Network Configure WEP It is recommended to enable WEP on your wireless router or access point before configuring your wireless adapter. If you are joining an existing network, you will need to know the WEP key being used. Open the Windows® XP Wireless Utility by right-clicking on the wireless computer icon in your system tray (lower-right corner of screen). Highlight the wireless network (SSID) you would like to connect to and click Connect. d-Link DWR-730 User Manual 39 Section 5 - Connecting to a Wireless Network 3. If the connection fails, please verify that the WEP settings are correct. D-Link DWR-730 User Manual 40 Section 5 - Connecting to a Wireless Network Configure WPA-PSK It is recommended that you enable WPA on your wireless router or access point before configuring your wireless adapter. If you are joining an existing network, you will need to know the WPA key being used. Open the Windows® XP Wireless Utility by right-clicking on the wireless computer icon in your system tray (lower-right corner of screen). Highlight the wireless network (SSID) you would like to connect to and click Connect. d-Link DWR-730 User Manual 41 Section 5 - Connecting to a Wireless Network 3. If the connection fails, please verify that the WPA-PSK settings are correct. The WPA-PSK passphrase must be exactly the same as on the wireless router. [. . . ] D-Link DWR-730 User Manual 52 Appendix C - Warnings and Declarations RF Exposure Information (SAR) This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. *Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands. [. . . ]