User manual D-LINK DSL-320T QUICK INSTALLATION GUIDE

[. . . ] First, connect the power adapter to the receptor at the back panel of the DSL-320T and then plug the other end of the power adapter to a wall outlet or power strip. Insert one end of the cable into the Ethernet port on the back panel of the DSL-320T and the other end of the cable to an Ethernet Adapter or available Ethernet port on your computer. Power Input Ethernet Port Connect to Ethernet cable Connect to power adapter To use your Web browser to access the web pages used to set up the Modem, your computer must be configured to "Obtain an IP address automatically, " that is, you must change the IP network settings of your computer so that it is a DHCP Client. [. . . ] the connection types available in the Setup Wizard window are PPPoE/PPPoA , Static IP Address , and Bridge Mode. Follow the instructions below for the type of connection you are using. PPPoE/PPPoA Connections If you selected the PPPoE/PPPoA connection type in the previous window, you will see the Setup Wizard window pictured here. Type in the Username and Password used to identify and verify your account to the ISP. If you have been instructed to change the VPI number and VCI number, type in the new values. Select the Connection Type used for encapsulation specific to your service. Click Next when you are ready to continue to the Setup Completed window. Static IP Address Connections If you selected the Static IP Address connection type, change the WAN IP Address, Subnet Mask, ISP Gateway Address, Primary DNS (Server IP) Address and (if available) Secondary DNS (Server IP) Address as instructed by your ISP. If you have been instructed to change the VPI number and VCI number, type in the new values. Click Next when you are ready to continue to the Setup Completed window. Bridge Connections If you selected the Bridge connection type, select the Connection Type used for encapsulation. If you have been instructed to change the VPI number and VCI number, type in the new values. Click Next when you are ready to continue to the Setup Completed window. Click the Restart button to save the new settings and restart the Modem. The window pictured on the right appears during the save and restart process. Use the following steps to configure a computer running Windows XP to be a DHCP client. [. . . ] The default setting is "0" which disables this functionality and the internet will be connected all the time. We suggest that you should change the Maximum idle timer to "300" (5 minutes) so that the device will drop the line after 5 minutes of inactivity and keep usage costs down. You can just leave this parameter unchanged or enable Auto-reconnect to be always on line. [. . . ]