User manual D-LINK DSC-350

[. . . ] (1) Turn on your computer (2) Insert the DSC-350 Driver CD into the CD-ROM (3) There are two ways to install the TWAIN & Device Drivers. Autorun Program You will see the drawing below while you insert the DSC-350 Driver CD into the CD-ROM. Manual Click Start, then Run. Type "drive:\win98\setup" if you are running Windows 98 or Windows Millenium Edition. Type "drive:\win2000\setup" if you are running Windows 2000. Replace drive with the letter of your CD-ROM. [. . . ] When making a video recording, the Red LED light in the front cover and Green LED light at the back cover will be blinking continuously. Select resolutions Snapshot This dual mode camera has 3 different resolutions to choose when taking still images. Press and hold the "Mode/Power" button first, and press shutter release button to switch to a different resolution. "SHI" mode: Under this mode, the images taken are in 1024x768 pixels resolution (by software interpolation). -8- "HI" mode: The images taken are in 640x480 pixels resolution. "S" mode: The pictures taken are in 320x240 pixels resolution. Video Recording You can choose between 2 resolutions when doing video recording. Use the same procedure to switch resolutions in video recording mode as you use in snapshot mode. The video taken is in 160x120 pixels resolution when there is no resolution indicator in the status LCD. Taking Pictures (DSC-350 Digital Camera and Video Camera) When taking still images or video recording: MAKE SURE THE DSC-350 is POWERED ON and SET AT THE MODE YOU NEED. Make sure you are able to locate the object you want to shoot through the view-finder. Note: 1. In order to save power, the camera will automatically power off if you don't use the camera for 1 minute. 2. You can check the memory left by holding "Delete/Remain" button. The LED display shows the percentage of memory left ( ) when you press and hold "Delete/Remain" button. Digital Still Camera (1) Press the "Mode/Power" button for 3 seconds to power on. (3) Use the Viewfinder to locate the object. -9- (4) Press the shutter release button for taking pictures. When the green LED light stops blinking and the "BUSY" indicator disappear in the status LCD, the image saving is done and the DSC-350 ready for next shot. Note: The focus range is from approximately 1. 5 inch (4cm ) to infinity. Please refer to the following chart to set the focus. - 60 inch (1. 5M) ~ infinity. - Around 1. 5 inch ( 4 CM ). - 10 - 2. Video Recording (5) Press the "Mode/Power" button for 3 seconds to power on. (6) Choose video recording mode and set the resolution (refer to setting camera). (refer to the data at focus ring) (8) Use the viewfinder to locate the object. Press and hold the shutter release button to being taking a video recording. [. . . ] For example, if you select pictures 0001, 0003 and 0010 to save to disk, and the prefix is "Pic". Then the pictures' file names will be Pic0001 jpg, Pic0003. jpg and Pic0010. jpg. A special case is that if there is a file named Pic0001. jpg in the directory already, the new downloaded picture 0001 will - 16 - be saved as Pic0001-1. jpg, automatically. Erasing pictures: Select the pictures you want to erase and click on the "ERASE" button. Note: The images stored in the camera will be erased when you click the erase button. [. . . ]